Owner's Manual Cadillac BLS - IFS Europe BV

460_OM_MY09.book Page 52 Wednesday, April 2, 2008 10:32 AM
52 Locks and car alarm
Reprogramming lock system
functions
Certain lock system functions can be reprogrammed.
We recommend that you contact
an authorised Cadillac workshop, see
page 248.
Checking the number of remote
controls
To check the number of remote controls that
are programmed for the car:
1 Insert the remote control into the ignition
switch and turn it to position 3.
2 Press and hold the button for more
than 2 seconds within 30 seconds of
turning the ignition switch to position 3.
3 The DIC will now display the number of
remote controls that are programmed for
your car, and which of these (1–5) is in
the ignition switch.
Example of DIC message:
Number of keys:
Active key number:
Changing the battery
WARNING
Keep the battery and other small components
of the remote control out of reach of
children.
NOTICE
The electronics of the remote control are
sensitive to electrostatic discharge. Incorrect
handling when changing the battery
can damage the remote control. Avoid
touching electronic components of the
remote control with your hands.
When the voltage of the remote control battery
drops below a certain level, the DIC will
display:
Remote control battery
low. Replace battery.
Change the battery as soon as possible to
avoid malfunctioning.
Battery: For optimum performance in all
temperatures and good service life, we
recommend the use of a Sony or Panasonic
CR2032, 3V lithium battery.
The battery should last for about 4 years of
normal use.
The battery type is marked on the inside of
the remote control. Avoid leaving fingerprints
on the faces of the battery.