User's Manual 686LCD/S & 686LCD/MG CPU Board

More documents

Recommendations

Info

$Course Material\Efficiently Coding Communication Protocols in C++ ...$

686LCD/S & 686LCD/MG CPU Board - Version 1.4.0 - 8. December 1997 Solid State Disk (SSD) Flash. BIOS Watchdog circuit Real-Time-Clock and CMOS Memory Secure CMOS option Battery Circuit Supports DIP32 Flash or SSD module with up to 8M byte Software driver handles SSD as normal hard disk drive. - System: American Megatrends, Industry standard, 128kB. - Video: Chips & Technologies, 44kB. - INSIDE BIOS extens.: Setup utility & SSD code, 64kB. - SCSI BIOS-extension: Adaptec SCSI Select, 24kB. (686LCD/MG only) Supervision of power supply and program execution. Startup delay. Service interval can be selected. Date, time and system config. (with battery backup). Security backup of CMOS memory within Flash BIOS for auto reload, if CMOS memory is lost. Exchangeable Li battery. CAUTION ! Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions. Note: The battery is protected against internal and external shorting. On-board Peripheral interfaces On-board protection System Bus Connectors On board Bus Power Supply Power Consumption Environmental Conditions Dimensions AT-keyboard interface, PS/2 mouse interface, 2 x RS232C or 1 x RS232C & 1 x RS/485 serial communication interface supported by NS16550 comp. UART’s. 1 x Parallel printer interface (Centronic, ECP, EPP mode). EIDE hard disk interface Floppy drive interface (2 x 360kB to 1.44MB) Standard VGA Controller with Flat Panel Port. All Peripheral interfaces intended for connection to external equipment are protected with EMI Suppression filters. 98 pin PC-AT bus edge connector. PC104-connector. PCI for Ethernet, VGA, EIDE etc. +5, +12 Volt (+/- 3%). Can operate at +5 volt only +3.6 Volt Battery (Lithium) 10-20W typical (Dependent on processor type) 0°C - 60°C operating temperature (forced cooling) 10% - 90% relative humidity (non-condensing) 190.9 mm x 122.9 mm x 20.0-35.0 mm (686LCD/S) 249.7 mm x 122.9 mm x 20.0-35.0 mm (686LCD/MG) INSIDE Technology A/S. Page 4 of 134
686LCD/S & 686LCD/MG CPU Board - Version 1.4.0 - 8. December 1997 3. Installation procedure. 1. Turn off the power supply. 2. Insert the system BIOS if not already installed. Socket pin 1 is located nearest to the Cache socket. The chip must be placed so eventually unconnected socket pins are nearest the Cache socket. 3. Insert the DRAM (be careful with the orientation). 4. Insert Cache Module if applicable. 5. Install the processor (be careful with the orientation), pin 1 closest to the center of the Cache socket. 6. Mount the Fan on the top of the processor and connect it to JPFAN connector. 7. Remove the battery protection strip. 8. Insert all external cables for hard disk, floppy, keyboard etc. except for flat panel. A CRT monitor must be connected in order to change CMOS settings to flat panel support. 9. Connect power supply to the CPU Card via the PWRCON. 10. Turn on the power. 11. Enter the BIOS setup by pressing the delete key during boot up. Use the “Load BIOS Optimal Defaults” feature. The Peripheral Setup and the Standard Setup Window must be entered and configured correctly to match the particular system configuration. 12. If Flat Panel Display is to be utilised, make sure the Panel voltage in the BIOS setup is correct before turning off the power and connecting the display cable and optionally the FPUM. Note: The CMOS memory may be in a undefined state at power-on after a period of no battery backup. To load the fail-safe CMOS settings press and hold down the key during power-up. INSIDE Technology A/S. Page 5 of 134
Page 1 and 2: User’s Manual 686LCD/S & 686LCD/M
Page 3 and 4: 686LCD/S & 686LCD/MG CPU Board - Ve
Page 9: 686LCD/S & 686LCD/MG CPU Board - Ve
Page 39 and 40: I/O Port Access Read/ Write DMA Mas
Page 41 and 42: I/O Port Access Read/ Write 686LCD/
Page 51 and 52: I/O Port Access Read/ Write 03FCh P
Page 61 and 62:
686LCD/S & 686LCD/MG CPU Board - Ve
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
7.17 PC-AT Edge Connector. 686LCD/S
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
show all

User's Manual 686LCD/S & 686LCD/MG CPU Board

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?