BlueMod+P2x/HDP - Stollmann
BlueMod+P2x/HDP - Stollmann
BlueMod+P2x/HDP - Stollmann
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>BlueMod+P2x</strong>/<strong>HDP</strong><br />
Configuration Reference<br />
<strong>HDP</strong>MCAPTO<br />
Syntax:<br />
Identifier type:<br />
hdpmcapto | hdpmcapto=<br />
configuration | source<br />
<strong>HDP</strong> MCAP Timeout<br />
This parameter defines a timeout for MCAP responses from the remote device. If<br />
this parameter is set to a value other than zero and a MCAP command is initiated<br />
from the local device but not responded by the remote device within the timeout<br />
interval the MCL (including all data channels that might be established) will be<br />
disconnected.<br />
Value<br />
Description<br />
0 No timeout defined<br />
1 – 65535 Timeout in milliseconds<br />
Example:<br />
hdpmcapto=30000<br />
MCAP timeout is 30s<br />
<strong>HDP</strong>NAME<br />
<strong>HDP</strong> Service Name<br />
Syntax:<br />
Identifier type:<br />
hdpname | hdpname=<br />
configuration | source<br />
This command sets the service name of the Health Device Profile SDP record.<br />
Example:<br />
hdpname=<strong>Stollmann</strong> <strong>HDP</strong><br />
Sets the name of the <strong>HDP</strong> SDP record to “<strong>Stollmann</strong> <strong>HDP</strong>”<br />
<strong>HDP</strong>RECONNECT<br />
<strong>HDP</strong>/MCAP Reconnect<br />
Syntax:<br />
Identifier type:<br />
hdpreconnect | hdpreconnect=<br />
configuration | source<br />
This parameter allows to enable/disable the support for the <strong>HDP</strong>/MCAP reconnect<br />
feature.<br />
Value<br />
Description<br />
0 Reconnect support disabled<br />
1 Reconnect support enabled<br />
Release r01 www.stollmann.de Page 30 of 43