Text and Layout: Stan Steez - Biglobe

22
• OUT Page: Mixer and Effect Settings
01.
Press [MODE] + Pad 11 to enter GLOBAL PROGRAM
EDIT Mode, then 'OUT' (F5).
J
02.
Set/change the following parameters... (for additional
info about the Mixer etc., please refer to chapters 13
and 14 of the AKAI manual v.2)
PAD: Use DATA wheel or Pad Bank Buttons to scroll/
jump through the pads. Press [WINDOW] to enter the
Velocity Layer Editor
LEVL: Adjust the output level of a pad (0-100).
PAN: Adjusts the Pan of a pad (L50 - R50)
OUT: Select the output of the signal from Stereo (ST),
Assignable Outs 1 and 2 (12), Assignable Outs 3 and 4
(34), Assignable Out 1 (1), Assignable Out (2), Left (L),
or Right (R).
FX: Select the effect applied to a pad: 'OFF', 'FX1' or
'FX2'. NOTE: you can only apply effects if the output is
set to Stereo (ST)!
NOTES:::
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
EQ / COMP: Turn the Master EQ and Compressor
on or off. Press [WINDOW] for setting up the EQ and
Compressor and other effects.
FX 1/2: Highlight the 'FX1' or 'FX2' fields to select/
change effects. Use DATA wheel to apply BIT GRUNGER,
4 BAND EQ, COMPRESSOR, PHASE SHIFTER, TREMOLO,
FLYING PAN, REVERB, or DELAY to the mixer. To Link
FX1 and FX2 together move the cursor to the 'OFF' field
in between FX 1 and 2, and turn the DATA wheel until
an arrow pointing down to FX2 is displayed
TIP: Use the WHOLE function to quickly apply settings
to all pads. Hold SHIFT while turning the DATA wheel
to increase the change of values by 10 times.
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
MPC 1000 v4 Operator’s Manual rev 3.5