Reference Guide - Propaq Encore Vital Signs Monitor - Welch Allyn

24 Getting started Welch Allyn Propaq Encore Vital Signs Monitor
Note
The alarm for apnea cannot be turned off at any time.
You can program the Propaq Encore to power up in any of the Factory patient modes or
the Custom patient modes. You can also change the current patient mode during
operation.
Note
Whenever you change the patient mode, the alarm limit settings automatically
change to the settings for that mode.
From the Main Menu, press SETUP, MORE, CHANGE, SETUP. The Mode Setup window
appears:
MODE SETUP BATTERY: 9.3 VOLTS ZEROED
FACTORY: *ADULT PED NEO P2 NO ZERO
MCO2
CUSTOM :
BR
ADULT PED NEO
* = PATIENT MODE ON POWERUP
NEXT POWERUP* USE NOW SAVE
38 12
mmHg
Sp02
97
PREV MENU
The asterisk (*) indicates which patient mode is currently selected for powerup.
NEXT Selects the next setting in the status window.
POWERUP* Selects the highlighted patient mode (and its associated settings) as
the powerup mode. The selected powerup mode is marked by an
asterisk (*). (This does not change the current patient mode.)
USE NOW Selects the highlighted patient mode (and its associated settings) as
the current patient mode. (This does not affect the powerup mode.)
SAVE Use this button to reprogram the settings of Custom patient mode:
1. Make sure the patient mode you want to reprogram (ADULT, PED
or NEO) is currently used. (To change patient modes, highlight the
desired mode and press USE NOW, YES.)
2. Exit the Mode Setup window, then use other menus and buttons to
set the monitor settings and alarm limits as desired.
3. Re-enter the Mode Setup window, highlight the desired Custom
mode, and press SAVE, YES.