Impala SS and Caprice T56 Six Speed install guide - GRAIL

More documents

Recommendations

Info

25. With the pedal assembly removed, you will see that the firewall has insulation on it. Take the main F2B bracket and align the four main mounting holes over where the booster bolts go through, it will not fit flush, draw an outline around the unit and cut out insulation where you marked. It should look close to this. 26. Now you are going to need to draw and outline the bracket again using the same method as described above, but this is going to be lower portion of the bracket where is going to protrude through the firewall. You will notice that the 14
acket overlaps the black mounting portion of the lower steering column, this will also have to be trimmed a bit so that the bracket can sit flush. Make an outline and cut, I always cut a bit small and enlarge from there for precise fit. Basically you should have something that looks like this. At the end of this document is a template that you can cut out to aid in marking this location, the cutout is about the right size, actually a little on the small side so that you can trim to fit. 27. The cutting procedure will take time, be patient and it will come out looking really nice. The next picture is what the unit will look like fully installed on the booster bolts coming through the firewall, in the F2B kit there is some insulation looking material that I never really figured how to make it work on the bracket, I discarded this and just made sure that I made the bracket fit precisely, I then used silicon around the entire assembly inside and out. Mount bracket to four booster bolts and install four original nuts 15
Page 1 and 2: Impala SS and Caprice T56 Six Speed
Page 3 and 4: Here we go First you are going to n
Page 5 and 6: 2. The F2B clutch pedal bracket kit
Page 7 and 8: As listed above the original cover
Page 9 and 10: 2. Take measurement from yoke, at t
Page 11 and 12: 15. Take the old transmission dipst
Page 13: 23. Remove door sill plates that ar
Page 17 and 18: The next picture shows where to cut
Page 19 and 20: 30. Next remove the two existing br
Page 21 and 22: wiring to mine and put it behind wh
Page 23 and 24: 41. Install retaining clip on rod o
Page 25 and 26: 46. Now to the bump out that you ar
Page 27 and 28: Towards engine Not all manufacturer
Page 29 and 30: marks up. (Note: most times balance
Page 31 and 32: 59. It is my recommendation that yo
Page 33 and 34: 66. Now route in the wiring that yo
Page 35 and 36: 77. Next install shifter onto shift
Page 37 and 38: 87. The last step is to have you PC
Page 39 and 40: Special Thanks A special thanks nee
Page 41 and 42: 2. IT will be like a jigsaw puzzle
Page 43 and 44: Impala SS and Caprice T56 Six Speed
Page 45 and 46: F2B bracket template to use for cut
Page 47 and 48: Impala and Caprice Brake Pedal and
Page 49 and 50: Fbody Clutch and Brake Pedal assemb
Page 51 and 52: Fbody wiring diagram sheet 2 51
Page 53 and 54: If the harness that you have from t
Page 55 and 56: 2. Locate wiring on the Caprice or
Page 57 and 58: Most times the pedal assembly from
Page 59 and 60: 4. Splice wiring to new pigtail ass
Page 61: 8. Attach harness assembly to switc

Impala SS and Caprice T56 Six Speed install guide - GRAIL

Create successful ePaper yourself

Delete template?

Save as template?