Impala SS and Caprice T56 Six Speed install guide - GRAIL
Impala SS and Caprice T56 Six Speed install guide - GRAIL
Impala SS and Caprice T56 Six Speed install guide - GRAIL
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
wiring to mine <strong>and</strong> put it behind where the ashtray used to go in my car. You may<br />
have to come up with something creative on this one.<br />
33. After you got the hole drilled <strong>and</strong> all the process listed before complete <strong>install</strong><br />
the cowl bracket into where you were just at, using provided fasteners in the<br />
kit.<br />
34. Remove the convenience center under the dash on the left h<strong>and</strong> side; this is<br />
where the chime module <strong>and</strong> the flasher cans reside. There are two 7mm bolts<br />
holding this in, one top <strong>and</strong> one on the bottom. Install bracket in F2B kit<br />
underneath this unit to shift it over to the left. It should look similar to this<br />
when you are complete<br />
35. Within the Steering column harness you are going to find a thick yellow wire<br />
within a bundle that also has a pink <strong>and</strong> a brown wire of the same thickness in<br />
it. What you are wiring in is the neutral safety switch that is located at the<br />
lower portion of the pedal assembly, underneath the clutch pedal. Before<br />
continuing <strong>and</strong> to make sure that you have the correct wire, measure continuity<br />
from this wire, by pricking insulation with one meter lead <strong>and</strong> going to fuse 24<br />
“CRANK” fuse, the lower pin <strong>and</strong> check to make sure that you have continuity.<br />
If all is good cut wire <strong>and</strong> splice in wiring from switch to essentially put switch<br />
in between wire, so that you have to press in the switch with the clutch pedal<br />
to get the car to start.<br />
36. Next is the fun part. Make sure switches are <strong>install</strong>ed on the pedal assembly<br />
<strong>and</strong> are in there approximate location. Grab the four provided bolts for in the kit<br />
for the pedals along with the single hex head bolt for the cowl bracket that you<br />
<strong>install</strong>ed earlier. Position the pedals under the dash so that you can plug in the<br />
brake light <strong>and</strong> cruise switch connectors.<br />
37. With the pedals in place start the four bolts into the F2B bracket on the firewall,<br />
loosely. Once these are <strong>install</strong>ed, <strong>install</strong> allen headed bolt into cowl bracket,<br />
snug. Tighten all four bolts ate main mount on pedal assembly <strong>and</strong> then final<br />
21