Impala SS and Caprice T56 Six Speed install guide - GRAIL
Impala SS and Caprice T56 Six Speed install guide - GRAIL
Impala SS and Caprice T56 Six Speed install guide - GRAIL
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
30. Next remove the two existing brake pedal switches from the original pedal<br />
assembly along with the clips that mount them to it <strong>and</strong> <strong>install</strong> on the F-Body<br />
assembly.<br />
31. If you are ready for a break, you can wire up the brake pedal <strong>and</strong> clutch pedal<br />
switches as listed in this drawing, you are going to need to get the connectors<br />
for the clutch pedal assembly. I lucked out in the <strong>install</strong>ation <strong>and</strong> they all came<br />
with the pedals. Wire as shown below. If you don’t have the harness from the F-<br />
Body pedals you can easily wire it using this diagram <strong>and</strong> an ohm meter.<br />
Attached at the end of this document is the full fabrication procedure for this<br />
wiring modification.<br />
Note: You can leave the clutch anticipate logic out of the system, but be warned, if<br />
this is not wired up, if you push the clutch in when cruise is engaged, you run the risk<br />
of over revving the engine.<br />
32. Well now that you have had break, back into the inside of the car to st<strong>and</strong> on<br />
your head a bit. What we are going to do is drill a hole in the Cowl brace. This is<br />
the brace that you see in next picture.<br />
19