MobileMapper 10 Getting Started Guide, rev A - ARVAtec

More documents

Recommendations

Info

English • Put the trap door back into place by first inserting the two lugs located at the bottom of the trap door. • Then push the door against the receiver case and rotate the two screws back in their initial positions to seal the battery compartment. Turning the Receiver On • Press the Power key [1] for a couple of seconds until you feel a vibration in your hand, then release the key. [1] Let the receiver run its boot sequence. Wait until the screen displays the Windows Mobile Home screen. The operating system used in the receiver is Microsoft Windows Mobile Professional version 6.5. For more information on how to use the different applications, you can visit the Microsoft web site at: http://www.microsoft.com/windowsmobile/en-us/help/v6-5/ Basics.aspx Depending on how long your product was stored in its package before being shipped to you, the remaining power in the battery may be too low to allow the receiver to operate for your entire working session. For this reason, the first thing to do is to check the battery charge status: • Tap on the title bar at the top of the screen. The Quick Toolbar appears just underneath. • Tap on the Battery icon. This opens the Power window and simultaneously closes the Quick Toolbar. The Power window shows the status of the battery (see also Internal Battery on page 13). If the remaining power is greater than 50%, then you can use the receiver without having to charge the battery first (with 50% of remaining charge, you can use the receiver for several hours). Skip the next section and go directly to Adjusting Backlight Level and Idle Time on page 4. • If it less, Ashtech recommends you first charge the battery as explained in Using the AC Adapter to Charge the Battery on page 3. 2
Using the AC Adapter to Charge the Battery Follow the instructions below. • Prepare the AC adapter: – Remove the protective cover [1] by pushing the button then sliding the cover forward. English [1] [2] [3] – Choose the plug that fits your country’s AC outlet standard (see [2]) and slide it into the AC adapter [3]. (A “click” must be heard when fully inserted.) • Take the USB cable provided [4]. Connect the end fitted with a standard USB connector to the AC adapter. Connect the other end (fitted with a mini-USB connector) to the bottom side of the receiver (open the flap [5] first). [4] [3] [4] [5] [4] • Connect the AC adapter to an electric outlet. After about 4 seconds, the receiver screen lights up. An icon shows up indicating that the battery is being charged. The screen is then turned back off after about <strong>10</strong> seconds. After this time, battery charging will continue at the same rate until the battery is fully charged (charging time: 4 hours max.). 3
Page 1 and 2: MobileMapper ® 10 Getting Started
Page 3 and 4: limitation of incidental or consequ
Page 5: Table of Contents First-Time Use ..
Page 10 and 11: English Using the Quick Toolbar •
Page 12 and 13: English Regional Settings It’s a
Page 14 and 15: English Receiver Description Front
Page 16 and 17: English [18] [19] Battery Compartme
Page 18 and 19: English If SBAS is used, the screen
Page 20 and 21: English Icon Meaning Battery high:
Page 22 and 23: English system, install new applica
Page 24 and 25: English Scrolling through Your Pict
Page 26 and 27: English Deleting a Picture • With
Page 28 and 29: English Deleting a Video • With t
Page 30 and 31: English Platform Specifications GNS
Page 32 and 33: English Standard Accessories • Po
Page 34: MobileMapper ® 10 Getting Started

MobileMapper 10 Getting Started Guide, rev A - ARVAtec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?