PT-19 ARF Assembly Manual - E-flite
PT-19 ARF Assembly Manual - E-flite
PT-19 ARF Assembly Manual - E-flite
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
9. Apply epoxy in the joiner pocket and root of the<br />
remaining wing panel.<br />
<br />
10. Slide the wing panels tightly together. Remove<br />
the T-pin from the joiner that was installed in Step<br />
4. Slide the wing panels tightly together. Again,<br />
work slowly to clean up any excess epoxy using a<br />
paper towel and rubbing alcohol.<br />
<br />
11. Use low-tack tape to hold the two wing panels<br />
together until the epoxy fully cures. Clean any<br />
excess epoxy from the wing panels using rubbing<br />
alcohol and a paper towel.<br />
You can use the two 4-40 x 1-inch socket head<br />
wing bolts and three rubber bands to hold the wings<br />
together while the epoxy cures. Simply insert the wing<br />
bolts half-way into the holes at the trailing edge and<br />
wrap a rubber band around the bolts on both the<br />
top and bottom of the wing. Use a third rubber band<br />
around the wing dowels. Always clean up any excess<br />
epoxy using a paper towel and rubbing alcohol.<br />
12 E-<strong>flite</strong> <strong>PT</strong>-<strong>19</strong> <strong>ARF</strong> <strong>Assembly</strong> <strong>Manual</strong>