OPTIMA System - Isover

More documents

Recommendations

Info

16 F 1 2 3 4 3. Cutting and installing the insulation material The insulation material should be cut to the height floor-ceiling plus 1 cm, and installed such that the OPTIMA2 Supports pierce the material; panels joints should be tight and flush (Picture 1). 4. Installing the keys of OPTIMA2 Supports Locate the key on the projecting end of the OPTIMA2 Support or OPTIMA2 Support Reno supports (Picture 2 point F). 5. Installing the vertical studs Insert the OPTIMA 240 Stud in the OPTIMA Floor Stud (Picture 3). Depending on the height required, affix either an OPTIMA 30 or 50 Stud and slide the extended stud into position in the OPTIMA Ceiling Stud from the side. Vertical studs are locked in position by the keys of OPTIMA2 Support or OPTIMA2 Support Reno pieces, first making sure studs are vertical using a spirit level (Picture 4).
6. Installation of the vapour retarding and air tight layer Once the metal studs are securely located, VARIO KM or VARIO KM Duplex UV can be applied as a vapour retardant, air tight layer. VARIO accessories, such as VARIO DS, an adhesive sealing compound, and VARIO ProTape, an adhesive tape, are used to fix the membrane to the studs, floor and ceiling. The construction is only air tight if VARIO KM / KM Duplex UV are bonded well to the floor and ceiling. Each membrane seam should overlap by a least 10 cm (Picture 1). Applying single-sided VARIO KB1 tape to all membrane seams ensures a reliable, tight seal. Overlapping the seams by at least 10 cm, and the tape’s powerful bonding strength avoids leaks in the system (Picture 2). Cable penetrations are made airtight with VARIO MultiTape SL. VARIO Stos or Mangete Passelec are also ideal for sealing off various other installations (Picture 3). 7. Cutting and fixing the facing The facing material should be cut to a length of the floor to ceiling height minus 1 cm. Hold the board flush to the ceiling and screw it directly to the studs (Picture 4), at 30 cm intervals, leaving a minimum of 1 cm perimeter from the edge of the board. 1 2 3 4 17
Page 1 and 2: Thermal and sound insulation OPTIMA
Page 3 and 4: High energy costs but a low comfort
Page 5 and 6: OPTIMA - System components 4 3 2 6
Page 7 and 8: Floor and Ceiling Studs (Item 1 in
Page 9 and 10: III. Vapour retarder and air tightn
Page 11 and 12: IV. Facing The finishing wall The O
Page 13 and 14: OPTIMA System - Solutions for ISOVE
Page 15: A dry system, easy to install The O
Page 19 and 20: OPTIMA System - Advantage after adv
Page 21 and 22: The Accessories OPTIMA Floor and Ce
Page 23 and 24: VARIO KB3 Single-sided, highly flex

OPTIMA System - Isover

Create successful ePaper yourself

Delete template?

Save as template?