CUTTING TOOLS

Accessories for Posidrill
1
CUTTING TOOLS
Type Clamping screw Key
19 793… 51 062…
P69003 905 006
P69004 910 007
P69005 920 009
P69006 925 010
19 793 WCMX tip
Type 19 793…
SP4034
WCMX 030204E - 60 700
WCMX 040204E - 60 705
WCMX 050308E - 60 710
WCMX 06T308E - 60 715
Posidrill Plus technical information
!
If possible, the surfaces to be drilled should always be flat. If the
angle between the drill/boring bar axis and the surface be more than
2°, the feed rate must be reduced by 1/3.
The feed rate should be reduced by 1/3 if concave surfaces are drilled.
The feed rate should be reduced for irregular surfaces to avoid breakouts
at the tips. Equally, the feed rate should be reduced when exiting
irregular surfaces.
The tap drill hole may not be larger than 1/4 of the drill diameter, as
otherwise the drill will be pushed away.
In the case of continuous through transverse drilling the penetration in
the workpiece may not be larger than 1/4 of the drill diameter. The
feed rate should be reduced by 50%.
“Turning” / “Parting” / “Milling”
Stacks of sheets and welded together sheets can be drill through with
the Posidrill Plus if they are clamped in a stable way.
The best results are achieved if the offset between the centreline of
the drill and the drill hole is not greater than 0.03 mm (upright use of
the tool).
The outer tip should be parallel to the machine’s longitudinal axis
when changing the drill (upright use of the tool).
362
ibemo Kazakhstan - 090301 Republic of Kazakhstan, West Kazakhstan Oblast, Aksai, Pramzone, BKKS office complex
Phone: +7 71133 93077 ; Fax: +7 71133 93074 ; E-Mail: info@ibemo-kz.com
“TOOLS”