CUTTING TOOLS

10 603 Solid carbide cooling duct drill bit Alpha 4 XD30
High-performance drill bit for deep holes
with wide range of uses, especially for steel materials including stainless
steels, cast iron materials
and non-ferrous metals.
With 4 radii for high drilling quality and alignment.
With special geometry and low-friction surface for drilling
deep holes up to 30xd without venting.
A 6985 TFP
10 603…
CUTTING TOOLS
1
Ø d1 10 603… d2 l1 l2 l4
mm mm mm mm mm
4.0 040 6 174 133 36
4.5 045 6 208 169 36
5.0 050 6 208 169 36
5.5 055 6 225 187 36
6.0 060 6 242 204 36
Ø d1 10 603… d2 l1 l2 l4
mm mm mm mm mm
6.5 065 8 268 228 36
7.0 070 8 268 228 36
8.0 080 8 294 256 36
8.5 085 10 330 287 40
!
Drilling strategy for ALPHA ® -XD
1.
2.
1,5xd
off
Pilot drillhole 1.5 x d with XD ® pilot. To this end
the diameter tolerances are matched to the
XD ® pilot.
Move the XD tool into the hole with max. 500 1/min.
3.
4.
1,5xd
10 – 30 bar
on
3xd
Tap with reduced cutting speed and feed rate to
approx. 3 x d.
To this end reduce cutting and feed rate to 25 –
50 % of the recommended TITEX ELECTRONIC
CONSULTANT values.
Increase the cutting speed and feed rate to the
recommended TITEX ELECTRONIC CONSULTANT
values (without interrupting feed, the drill bit must
be engaged). Continue drilling without venting!
5.
off
After reaching the drilling depth, reduce the speed
to max. 500 1/min or stop the spindle.
Remove the drill bit from the hole.
Recommended flow
rate and pressure
XD ® technology,
2 helical channels
Q (litre/min.)
5
4,5
4
3,5
20 bar A 6685
20 bar A 6985
3
2,5
2
1,5
1
0,5
Tool diameter in mm
0
3,0 3,5 4,0 4,5 5,0 5,5 6,0 6,5 7,0 7,5 8,0 8,5 9,0 9,5 10,0 10,5 11,0 11,5 12,0
Drilling and centring tools
ibemo Kazakhstan - 090301 Republic of Kazakhstan, West Kazakhstan Oblast, Aksai, Pramzone, BKKS office complex
“TOOLS”
Phone: +7 71133 93077 ; Fax: +7 71133 93074 ; E-Mail: info@ibemo-kz.com
95