Mx1100 Serial BTR for GE Manual - Memex Automation
Mx1100 Serial BTR for GE Manual - Memex Automation
Mx1100 Serial BTR for GE Manual - Memex Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Helpful hints<br />
<br />
<br />
Some combinations of DNC software and CNC control<br />
sometimes miss the end of an uploaded file. Adding a couple<br />
of Carriage Returns to the end of the file as a buffer will<br />
ensure that the entire file is transmitted.<br />
The <strong>BTR</strong> responds to the Break character by resetting<br />
and clearing its buffer. The Break character is ASCII<br />
value 3, or HEX 03 (see Appendix B, page 21). If your<br />
DNC software can be configured to send control codes,<br />
it’s a good idea to have it send a Break character at the<br />
beginning of every part program. This will guarantee that<br />
the <strong>BTR</strong> buffer is reset and ready <strong>for</strong> a new program<br />
each time, even if the CNC didn’t properly finish reading<br />
the previous one. (The Break character will not be<br />
passed through to the CNC, and the start of the program<br />
following it will wait while the <strong>BTR</strong> is resetting.)<br />
Operating _ 7<br />
4 _ Mx1000 User’s <strong>Manual</strong>