MIRAGE - Carefree of Colorado

MIRAGE Service Manual Carefree of Colorado
D03A AWNING DOES NOT AUTO-RETRACT IN WIND (STANDARD ELECTRONICS)
NOTE: For standard electronics with the optional auto-retract anemometer; the auto-retract system is always on.
Confirm that the sensitivity is set correctly (if set on highest level, system may appear not to function). Setting the
sensitivity is in the Owner's manual and on page 26.
A
B
Confirm that the retract function works using the PATIO
switch
YES
NO
Function works using the switch; go to
test B
Function does not work with switch; go
to procedure D01
Test Anemometer
1 Do the anemometer cups spin freely YES Go to step B2
NO Anemometer defective - replace
2 Test signal from anemometer:
YES Control Box is defective - replace
2.1 Remove anemometer wires from control box;
NO The circuit stays open or stays closed;
2.2 Place continuity tester between anemometer
go to step B3
wires;
2.3 Have a helper slowly turn the anemometer:
Does the circuit open and close It should open
and close once for every revolution.
3 Test the wire continuity between the control box and the YES Continuity OK; replace anemometer
anemometer.
NO Repair or Replace wires as required
D03B AWNING DOES NOT AUTO-RETRACT IN WIND (DIRECT RESPONSE)
A
Press the power on button then press the auto-retract button.
Does the auto-retract LED flash
YES
NO
The flashing LED indicates that the
sensor has been disengaged or
otherwise disabled. Go to step C.
Function does not work with switch;
go to procedure D01
B Confirm that the retract function works using the push buttons. YES Function works using the switch; go
to test C
NO Function does not work with switch;
go to procedure D01
C Test Motion Sensor
1 Confirm cable is plugged into connector on box marked YES Go to step 2
“Shaker”
NO Correct as required and test.
2 2.1 Unplug sensor from control box.
2.2 Connect a second sensor into control box.
2.3 Set the control switches for the auto retract function
2.4 Hold the second sensor horizontally and gently move
up and down.
YES
NO
Awning retracts; original sensor
defective - replace
Awning does not retract; control box
defective - replace
12 052979-301r6