LTO half-height SAS Tape Drives User Guide - Tandberg Data
LTO half-height SAS Tape Drives User Guide - Tandberg Data
LTO half-height SAS Tape Drives User Guide - Tandberg Data
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Reboot the server<br />
3. Connect the <strong>SAS</strong> and power cables to the tape drive and plug the other<br />
end of the power cable into the power outlet.<br />
1. <strong>SAS</strong> connector<br />
3. Power on/off switch<br />
2. Power connector<br />
Figure 3-2 Connecting the cables to the tape drive<br />
Caution<br />
Always use the supplied power cable, which<br />
is correct for your geographical location.<br />
Reboot the server<br />
Switch on the tape drive and power up the server. The power on/off switch<br />
is on the front panel.<br />
Watch the boot screen carefully after installation. If there are any error or<br />
unexpected messages go back and check the cabling carefully.<br />
If this does not resolve the problem, refer to “Troubleshooting” on page 49<br />
for further guidelines.<br />
March 2010<br />
#<br />
27