Ixia Black Book: SDN/OpenFlow

More documents

Recommendations

Info

Test Case: OpenFlow Switch Forwarding Test Step by Step Instructions The following steps describe the procedure for performing the test. 1. Reserve 3 Ixia ports (1 for controller and 2 port traffic endpoints) Figure 20: Port Selection window 2. Enable OpenFlow on all the ports by selecting the OpenFlow check box on the Protocols window. Figure 21: RoutingSwitching tab, Protocols window PN 915-2635-01 Rev A December 2012 23
Test Case: OpenFlow Switch Forwarding Test 3. Configure the emulated controller IP address and Gateway address from the Connected Interface tab on the Protocol Interfaces window. Use the IP address of the OpenFlow switch if you have only one switch. For Of Channel, ensure that ARP is resolved. You do not have to configure anything on host port. Figure 22: Connected Interfaces tab, Protocol Interface window 4. Define the port role by selecting the role from the Port Role list on the Ports tab on the OpenFlow window. You can select any of the following port roles: a. Control: for Controller port b. Traffic: for host ports PN 915-2635-01 Rev A December 2012 24
Page 1: ADVANCED MPLS Black Book Edition 8
Page 5: SDN/OpenFlow Contents How to Read t
Page 8 and 9: SDN/OpenFlow Dear Reader Ixia’s B
Page 10 and 11: Introduction - Software Defined Net
Page 12 and 13: Introduction - Software Defined Net
Page 14: Introduction - Software Defined Net
Page 17 and 18: Test Case: OpenFlow Switch Setup an
Page 30 and 31: Test Case: OpenFlow Switch Forwardi
Page 52 and 53: Test Case: Switch Flow Failover Per
Page 74 and 75: Contact Ixia Corporate Headquarters

Ixia Black Book: SDN/OpenFlow

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?