Ixia Black Book: SDN/OpenFlow

More documents

Recommendations

Info

Test Case: Switch Flow Failover Performance Test Setup Figure 38: Switch Flow Failover Performance Test, test setup Step by Step instructions 1. Reserve 4 Ixia port (1 for controller and 3 for data plane traffic) Figure 39: Port Selection window PN 915-2635-01 Rev A December 2012 45
Test Case: Switch Flow Failover Performance Test 2. Enable OpenFlow on all 4 ports by selecting the OpenFlow check box on the RoutingSwitching tab on the Protocols window. Figure 40: RoutingSwitching tab, Protocols window 3. Go to Connected Interface tab to configure Emulated Controller IP Address and Gateway Address. Use OpenFlow switch’s IP address if you have only one switch. Ensure that ARP is resolved for for OF Channel. Do not configure anything on host ports. Figure 41: Connected Interface tab PN 915-2635-01 Rev A December 2012 46
Page 1:
ADVANCED MPLS Black Book Edition 8
Page 5: SDN/OpenFlow Contents How to Read t
Page 8 and 9: SDN/OpenFlow Dear Reader Ixia’s B
Page 10 and 11: Introduction - Software Defined Net
Page 12 and 13: Introduction - Software Defined Net
Page 14: Introduction - Software Defined Net
Page 17 and 18: Test Case: OpenFlow Switch Setup an
Page 30 and 31: Test Case: OpenFlow Switch Forwardi
Page 52 and 53: Test Case: Switch Flow Failover Per
Page 74 and 75: Contact Ixia Corporate Headquarters
show all

Ixia Black Book: SDN/OpenFlow

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?