2 - Big Ass Fans

8
ELEMENT ®
Mounting Structure: Bar Joists
If you are installing the fan to an I-beam and have attached the upper yoke, proceed to “Hanging the Fan” (p. 13).
WARNING: The fan should not be installed unless the structure on which the fan is to be mounted is of sound
construction, undamaged, and capable of supporting the loads of the fan and the method of attachment to the structure.
A structural engineer should verify that the structure is adequate prior to fan installation. Verifying the stability of the
mounting structure is the sole responsibility of the customer and/or end user, and Big Ass Fans hereby expressly
disclaims any liability arising therefrom, or arising from the use of any materials or hardware other than those supplied by
Big Ass
WARNING: Never use beam clamps when mounting the fan to angle irons! Beam clamps are only intended for I-beam
installations.
CAUTION: Do not install the fan from a single purlin, truss, or bar joist.
CAUTION: Unsupported angle iron spans should not exceed 12 ft (3.7 m).
CAUTION: The angle irons must be fastened to the roof structure at each end.
CAUTION: Ensure the mounting location will not expose the fan to direct contact with water unless the fan is labeled,
“Suitable for use in wet locations.”
1. Select proper angle irons
Angle iron span
Minimum angle iron dimensions
Number of angle
irons needed
4 1
1.
Angle Iron Side View
(see table for dimensions)
Height
Width
Thickness
6’ (1.8m) or less
over 6’ (1.8m) - 8’ (2.4m)
over 8’ (2.4m) - 12’ (3.7m)
WWW.BIGASSFANS.COM ©2011 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED