Owner's Manual - Faria Instruments
Owner's Manual - Faria Instruments
Owner's Manual - Faria Instruments
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Edit Mode<br />
The “Edit” mode is used to adjust or set<br />
the values of numerous functions and<br />
options in the MG2000. The procedure<br />
below specifies the steps to be taken<br />
in the “Edit” mode to adjust / set each<br />
option.<br />
To enter “Edit” mode press the “Mode”<br />
and “Up” buttons while in “Normal”<br />
mode.<br />
To return to “Normal” mode press the<br />
“Mode” button once while in “Edit” mode.<br />
If no buttons are pushed for 30 seconds,<br />
the unit will exit “Edit” mode and return to<br />
“Normal” mode.<br />
Functions that are set, adjusted or<br />
observed in the “Edit” mode<br />
1. Reset Fuel Used<br />
2. Set Fuel Tank Full<br />
3. Set Amount Of Fuel<br />
4. Select Gauge Range (tach dial)<br />
5. Calibrate Trim Sender (Down, UP<br />
and Trailer”)<br />
6. Select Engine Position (Starboard,<br />
Port, Starboard Inner and Port<br />
Inner)<br />
7. Select Display Units (Pressure,<br />
Volume, Temperature, Distance<br />
and Depth)<br />
8. Select Fuel Tank Size (Standard<br />
= 25, 36, 40, 50, 55, 80 and 120.<br />
Others 0 to 999)<br />
9. Low Fuel Alarm<br />
10. Fuel Tank Calibrate<br />
11. Software ID and Revision<br />
12. Depth Sounder Warnings (Shallow<br />
0 to 99.9 ft. Keel offset +/- 19.9 ft)<br />
13. Self Test<br />
14. Enable Display Screens<br />
15. Configure Speed (Calibrate Pitot,<br />
Calibrate Paddlewheel, and Set<br />
Transition Speed)<br />
16. Invert Steering Angle (Normal and<br />
Inverted)<br />
17. Helm Select (Helm 1 and Helm 2)<br />
18. Pitot Select (100 PSI and 200<br />
PSI)<br />
19. Master Reset<br />
20. Tank2 Name (Tank2 Level, Fuel2<br />
Level, Oil Level, Waste Water, and<br />
Water Level<br />
21. Engine Type<br />
22. Calibrate Trim Sync<br />
Page 11