Manual 31 Guidelines for calibrating a binder distributor ... - Aapaq.org

More documents

Recommendations

Info

The angle of the long axis of the nozzle openings is set so that the spray fans will not interfere with each other. The nozzle angle varies according to the make of distributor and normally range between 15 and 30 degrees. The various manufacturers usually furnish special wrenches for setting the angle of the nozzles. The use of these wrenches is recommended, as it is extremely difficult to obtain a uniform spread with a visually set nozzle. Figure 10: Illustration showing the measurement of the nozzle angle Figure 11: Nozzle set at recommended angle 18
Figure 12: Effect of improper nozzle angles 19
Page 2 and 3: Manual 31 Guidelines for calibratin
Page 4 and 5: CONTENTS ACKNOWLEDGEMENTS . . . . .
Page 6 and 7: ACKNOWLEDGEMENTS This manual was or
Page 8 and 9: It is also encumbent on the owner o
Page 10 and 11: Except for distributors that are us
Page 12 and 13: A.3.3 Temperature gauges (thermomet
Page 14 and 15: A.3.5 Dipstick and guide The dipsti
Page 16 and 17: A.5 Pipework All pipes and coupling
Page 20 and 21: PART B: DETAILS OF THE INSPECTION A
Page 22 and 23: • a government run testing and ca
Page 24 and 25: Road speed The vehicle is to be fit
Page 26 and 27: B.5.1 Dipstick calibration test - (
Page 28 and 29: Figure 14: Apparatus to be used for
Page 30 and 31: B.5.7 Volume measurements All volum
Page 32 and 33: PART C: CHECKS, PROCEDURES AND TEST
Page 34 and 35: For best results, the height of the
Page 36 and 37: APPENDIX A Binder Distributor inspe
Page 38 and 39: A.4 Requirements for pump output Ye
Page 40 and 41: APPENDIX B Modification and mainten
Page 42 and 43: Distributor Date Identification Num
Page 44 and 45: 1.8 Was the 'Bucket Test' satisfact
Page 46: APPENDIX F Checks required after ea

Manual 31 Guidelines for calibrating a binder distributor ... - Aapaq.org

Create successful ePaper yourself

Delete template?

Save as template?