Manual 31 Guidelines for calibrating a binder distributor ... - Aapaq.org

More documents

Recommendations

Info

It is also encumbent on the owner of the binder distributor to ensure that the driver and sprayer operator are not only competent to carry out the operational procedures as required but that they are trained to apply the prescribed safety procedures and are equipped with the necessary safety equipment. It is recommended that all the personnel associated with the handling of binders during the spraying operating should have completed the BitSafe training course. The document is divided into three parts as follows: • Part A: General information • Part B: Calibration at a testing facility • Part C: On site checks, procedures and testing 8
PART A: GENERAL INFORMATION Binder distributors consist of a number of components each of which needs to be in good working order to ensure that the required application rate of binder is achieved. The following paragraphs provide some general information regarding the condition of the various distributor mechanisms and procedures applicable to ensure good performance. A.1 Distributor identification number Each binder distributor is marked with a unique identification number. This identification number is to be permanently attached or engraved on all of the following distributor components: • The distributor vehicle • The tank • The dipstick • The spray bar • The pump • The thermometers • The pressure gauges • The speed tachometer and fifth wheel. A.2 Vehicle It is the supplier’s responsibility to ensure that the distributor is in a roadworthy condition at all times. The distributor should be able to accelerate fast enough from a standing start with the tank filled to capacity to reach and maintain the speed required to apply the required rates of application. The vehicle shall also comply with all the legal requirements covering the vehicle and its equipment. A.3 Binder tank The tank is constructed or mounted in such a way that it can be completely emptied when the distributor is standing on level ground. 9
Page 2 and 3: Manual 31 Guidelines for calibratin
Page 4 and 5: CONTENTS ACKNOWLEDGEMENTS . . . . .
Page 6 and 7: ACKNOWLEDGEMENTS This manual was or
Page 10 and 11: Except for distributors that are us
Page 12 and 13: A.3.3 Temperature gauges (thermomet
Page 14 and 15: A.3.5 Dipstick and guide The dipsti
Page 16 and 17: A.5 Pipework All pipes and coupling
Page 18 and 19: The angle of the long axis of the n
Page 20 and 21: PART B: DETAILS OF THE INSPECTION A
Page 22 and 23: • a government run testing and ca
Page 24 and 25: Road speed The vehicle is to be fit
Page 26 and 27: B.5.1 Dipstick calibration test - (
Page 28 and 29: Figure 14: Apparatus to be used for
Page 30 and 31: B.5.7 Volume measurements All volum
Page 32 and 33: PART C: CHECKS, PROCEDURES AND TEST
Page 34 and 35: For best results, the height of the
Page 36 and 37: APPENDIX A Binder Distributor inspe
Page 38 and 39: A.4 Requirements for pump output Ye
Page 40 and 41: APPENDIX B Modification and mainten
Page 42 and 43: Distributor Date Identification Num
Page 44 and 45: 1.8 Was the 'Bucket Test' satisfact
Page 46: APPENDIX F Checks required after ea

Manual 31 Guidelines for calibrating a binder distributor ... - Aapaq.org

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?