Manual 31 Guidelines for calibrating a binder distributor ... - Aapaq.org

More documents

Recommendations

Info

Distributor Date Identification Number Stake values Spray No eg Prime, first spray, second spray APPENDIX D Spray performance log A pplication rates (L/ m 2 ) Binder R equired A ctua l Differenc e A ccepted Signatur e 42
APPENDIX E Check list before spraying commences on site Distributor Identification Number No. Item Yes No 1.1 Does the distributor have a valid Calibration Certificate • Was the calibration issued by a SANAS accredited facility • Is the certificate within its validity period • Does the certificate specify which components of the distributor have been calibrated and is there proof of calibration from an accredited facility that other components have also been calibrated and are their certificates valid 1.2 Check the Modification and maintenance log: are all modifications acceptable and recorded and have these modifications been re-calibrated (If deemed necessary) and is there proof of it in the logbook. 1.3 Check if all the relevant equipment mentioned in the above two items correspond (In terms of identification) to the respective certificates of calibration. 1.4 Inspect the 'Bucket' Test record. 1.5 Inspect the Performance log. 1.6 Has the distributor inspection check been carried out successfully (see Appendix A). 1.7 After inspection of the 'Bucket Test' record and the Performance log; does the client or his agent require that a 'Bucket Test' be done ... continued overleaf 43
Page 2 and 3: Manual 31 Guidelines for calibratin
Page 4 and 5: CONTENTS ACKNOWLEDGEMENTS . . . . .
Page 6 and 7: ACKNOWLEDGEMENTS This manual was or
Page 8 and 9: It is also encumbent on the owner o
Page 10 and 11: Except for distributors that are us
Page 12 and 13: A.3.3 Temperature gauges (thermomet
Page 14 and 15: A.3.5 Dipstick and guide The dipsti
Page 16 and 17: A.5 Pipework All pipes and coupling
Page 18 and 19: The angle of the long axis of the n
Page 20 and 21: PART B: DETAILS OF THE INSPECTION A
Page 22 and 23: • a government run testing and ca
Page 24 and 25: Road speed The vehicle is to be fit
Page 26 and 27: B.5.1 Dipstick calibration test - (
Page 28 and 29: Figure 14: Apparatus to be used for
Page 30 and 31: B.5.7 Volume measurements All volum
Page 32 and 33: PART C: CHECKS, PROCEDURES AND TEST
Page 34 and 35: For best results, the height of the
Page 36 and 37: APPENDIX A Binder Distributor inspe
Page 38 and 39: A.4 Requirements for pump output Ye
Page 40 and 41: APPENDIX B Modification and mainten
Page 44 and 45: 1.8 Was the 'Bucket Test' satisfact
Page 46: APPENDIX F Checks required after ea

Manual 31 Guidelines for calibrating a binder distributor ... - Aapaq.org

Create successful ePaper yourself

Delete template?

Save as template?