Manual 31 Guidelines for calibrating a binder distributor ... - Aapaq.org

More documents

Recommendations

Info

1.8 Was the 'Bucket Test' satisfactory or if 'Bucket Test' not deemed necessary Has a short preliminary spray been done to check for blocked nozzles, incorrect nozzle angles and to check that all the spraying equipment is in an acceptable working condition 1.9 Update 'Bucket Test' record. 1.10 Check that product information is as required and complete, i.e. Base Bitumen, Batch Number etc. Specify reference numbers: ……………………………………………………… …………………………………………….......…… 1.11 Verify spray applications for the project: • Rate of application: ……………………. • Spray width: ...…………………………. • Spray length: ...………………………… • Spray temperature: ...…………………. 1.12 Are the following in place and/or correct (If applicable): • Fishplate; • Spray bar height (overlap as required); • Has the spray bar been heated up; • Nozzles all of the same size and type, and all at the correct angle; • Sieves clean and spares available; • Cut off paper in place (start and end of run); • Kerbs or other features protected from binder; • Are there sufficient tins available for sampling the binder. ... continued overleaf 44
1.13 Is the trial section satisfactory • Required rate of application ……………….. • Actual rate of application …………………... If all of the above items are found satisfactory to the client or his agent, spraying may commence. 45
Page 2 and 3: Manual 31 Guidelines for calibratin
Page 4 and 5: CONTENTS ACKNOWLEDGEMENTS . . . . .
Page 6 and 7: ACKNOWLEDGEMENTS This manual was or
Page 8 and 9: It is also encumbent on the owner o
Page 10 and 11: Except for distributors that are us
Page 12 and 13: A.3.3 Temperature gauges (thermomet
Page 14 and 15: A.3.5 Dipstick and guide The dipsti
Page 16 and 17: A.5 Pipework All pipes and coupling
Page 18 and 19: The angle of the long axis of the n
Page 20 and 21: PART B: DETAILS OF THE INSPECTION A
Page 22 and 23: • a government run testing and ca
Page 24 and 25: Road speed The vehicle is to be fit
Page 26 and 27: B.5.1 Dipstick calibration test - (
Page 28 and 29: Figure 14: Apparatus to be used for
Page 30 and 31: B.5.7 Volume measurements All volum
Page 32 and 33: PART C: CHECKS, PROCEDURES AND TEST
Page 34 and 35: For best results, the height of the
Page 36 and 37: APPENDIX A Binder Distributor inspe
Page 38 and 39: A.4 Requirements for pump output Ye
Page 40 and 41: APPENDIX B Modification and mainten
Page 42 and 43: Distributor Date Identification Num
Page 46: APPENDIX F Checks required after ea

Manual 31 Guidelines for calibrating a binder distributor ... - Aapaq.org

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?