English - Summa Online

More documents

Recommendations

Info

<strong>Summa</strong>Cut Series Cutters User’s Manual Before lowering the pinch rollers, carefully check the position of the rollers in relation to the drive sleeves. When the pinch rollers are DOWN, the two rollers must run over the sleeves in order to ensure proper media traction. It is very important that both media edges always rest on the sleeves in such a way that the two pinch rollers, which are positioned 3 to 15 mm (0.1" to 0.6") from the media edge, will run over the sleeves when lowered to the drive drum. 1.8.2. FEEDING AND POSITIONING MEDIA The loading procedure described below has been found to give excellent repeatability. When loading media, adhere to these step-by-step instructions strictly. è To load media, proceed as follows: 1. Raise the pinch rollers by means of the pinch roller lever arm located on the right-hand side of the cutter. FIGURE 1-8 : PINCH ROLLER LEVER. 2a. When working with roll media and the roll feed, proceed by placing the roll of media horizontally on a table or on another easy-to-reach surface. Make sure that the front edge of the media is at the bottom and pointing away from you. If not, turn the roll. Remove the roll feed from under the machine. Remove the loose core holder. Insert the shaft into the media roll from the right hand side, and press the core holder into the core. Press the shaft further, so that it comes out at the other side of the roll. Insert the loose core holder from the left hand side. Place this assembly back under the cutter. General Information 1-21
<strong>Summa</strong>Cut Series Cutters User’s Manual FIGURE 1-9 FEEDING ROLL MEDIA General Information 1-22
Page 2 and 3: USER’S MANUAL FOR THE S e r i e s
Page 4 and 5: NOTICE Summa reserves the right to
Page 6 and 7: User’s Manual SummaCut Series Cut
Page 8 and 9: User’s Manual SummaCut Series Cut
Page 10 and 11: SECTION 1 GENERAL INFORMATION 1.1.
Page 12 and 13: SummaCut Series Cutters User’s Ma
Page 34 and 35: SECTION 2 OPERATION 2.1. THE CONTRO
Page 48 and 49: SECTION 4 INTERFACE 4.1. INTRODUCTI
Page 62 and 63: APPENDIX A MEDIA CERTIFICATION Type
Page 64: User’s Manual SummaCut Series Cut

English - Summa Online

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?