English - Summa Online
English - Summa Online
English - Summa Online
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Summa</strong>Cut Series Cutters<br />
User’s Manual<br />
4. To redirect the output to serial port #1, enter the following command at<br />
the system prompt: MODE LPT1:=COM1:.<br />
5. To redirect the output to serial port #2, enter the following command at<br />
the system prompt: MODE LPT1:=COM2:.<br />
6. The computer end of the cable must be plugged into the serial port<br />
defined as COM1 (or COM2). The cutter’ s baud rate must be set to 9600,<br />
with parity NONE and RTS/DTR mode set to TOGGLE.<br />
4.2.1.2. Windows 3.xx.<br />
è<br />
To set up your system, proceed as follows:<br />
1. Select “Main group” in the Program Manager. Select “Control Panel’,<br />
then “Ports” and then the port that is connected to the cutter. Press the<br />
“Settings” Button to see the port settings.<br />
2. The default settings of the cutter are as follow:<br />
• Baudrate : 9600 (see 2.2.12.)<br />
• Data Bits : 8<br />
• Parity : none (see 2.2.14.)<br />
• Stop Bits: 2<br />
• Flow Control : Hardware or Xon / Xoff<br />
4.2.1.3. Windows 95<br />
è<br />
To set up your system, proceed as follows:<br />
1. Press the “Start” Button and select “Settings”, continued by “Control<br />
Panel”. Press on the “System” icon and select the “Device Manager” tab.<br />
Select the port that is connected to the cutter and click on the properties<br />
button. Select the “Port Settings” tab to set the port settings.<br />
2. Analogous to 4.2.1.2.<br />
Interface 4-2