Ondatherm 900 Installation Guide - PGA Consultants

More documents

Recommendations

Info

8.12.1. Flashings overlap Laps can be done: • Overlapping the flashings 100 mm and adding a sealant butyl tape 15 mm from the end and in front of the stitching screws or using butt straps to achieve a flush joint use tapes as above • Joining obtusely to an underlay sheet with sealant tapes 15 mm from the ends of the two pieces of flashing and in front of the stitching screws. ArcelorMittal Construction Page 14 of 21 Javier Cirauqui
Annexes The next annexes are showed as example and orientation, ArcelorMittal Construction is not responsible about the right use of them. Other alternatives are possible and the customer must check if the information is enough for his company. ArcelorMittal Construction Page 15 of 21 Javier Cirauqui
Page 1 and 2: Edition: October 2011 Installation
Page 3 and 4: 1. Basic principles Every project h
Page 5 and 6: The materials must be distributed o
Page 7 and 8: 6. Cutting and drilling during inst
Page 9 and 10: 8. System fixation description 8.1.
Page 11 and 12: 8.7. Drainage Dimensions of gutters
Page 13: 8.10. Securing for uplift Products
Page 17 and 18: Only if cutting list, drawings have
Page 19 and 20: Flashings cutting list Customer Wor
Page 21: II. Installation ratios Installatio

Ondatherm 900 Installation Guide - PGA Consultants

Create successful ePaper yourself

Delete template?

Save as template?