Ondatherm 900 Installation Guide - PGA Consultants

More documents

Recommendations

Info

3.1. Lifting the material Bundles must be handled properly to avoid damaging the material. Bundles can be handled with: • Sling belts • Sling belts and spreader beam • Fork lift 3.2. Packaging and storage on site Avoiding the retention of water between sheets and panels is a must to avoid corrosion. Bundles must be stored with a slop of 1% to facilitate the evacuation of the water. ArcelorMittal Construction Page 4 of 21 Javier Cirauqui
The materials must be distributed on site as close as possible to the area where they will be installed. Bundles can not be stacked on top of each other on the construction site. They can be delivered stacked but they must be unloaded and stored separately. When lifting the bundles to the roof, you must secure them to avoid sliding sheets or panels. Before leaving bundles on the roof, you must check with the contractor that the structure can support the bundled weight. 3.3. Un-packaging When you unpack the materials you have to take care about the risk of displacements of the materials or up-lifting them due to the wind action. Waste material has to be taken to the proper place to avoid dirty and risk of accidents. 3.4. Protective film Coated products are supplied with a removable protective film to prevent mechanical damage during transport and assembly. This film must be removed 15 days after outside storage exposed to weather and/or immediately after installation, whichever is soonest. 4. Safety The work site must have the collective protective measures installed properly before starting the works. These protections must be defined according with the requirements of the safety project created by the General contractor. Employees must be equipped with the individual protections appropriated for the job that they are doing. Some of the protections are: helmets, gloves, boots, harness, etc. ArcelorMittal Construction Page 5 of 21 Javier Cirauqui
Page 1 and 2: Edition: October 2011 Installation
Page 3: 1. Basic principles Every project h
Page 7 and 8: 6. Cutting and drilling during inst
Page 9 and 10: 8. System fixation description 8.1.
Page 11 and 12: 8.7. Drainage Dimensions of gutters
Page 13 and 14: 8.10. Securing for uplift Products
Page 15 and 16: Annexes The next annexes are showed
Page 17 and 18: Only if cutting list, drawings have
Page 19 and 20: Flashings cutting list Customer Wor
Page 21: II. Installation ratios Installatio

Ondatherm 900 Installation Guide - PGA Consultants

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?