Ondatherm 900 Installation Guide - PGA Consultants

The materials must be distributed on site as close as possible to the area where
they will be installed.
Bundles can not be stacked on top of each other on the construction site.
They can be delivered stacked but they must be unloaded and stored
separately.
When lifting the bundles to the roof, you must secure them to avoid sliding
sheets or panels.
Before leaving bundles on the roof, you must check with the contractor that the
structure can support the bundled weight.
3.3. Un-packaging
When you unpack the materials you have to take care about the risk of
displacements of the materials or up-lifting them due to the wind action.
Waste material has to be taken to the proper place to avoid dirty and risk of
accidents.
3.4. Protective film
Coated products are supplied with a removable
protective film to prevent mechanical damage
during transport and assembly. This film must
be removed 15 days after outside storage
exposed to weather and/or immediately after
installation, whichever is soonest.
4. Safety
The work site must have the collective protective measures installed properly
before starting the works.
These protections must be defined according with the requirements of the
safety project created by the General contractor.
Employees must be equipped with the individual protections appropriated for
the job that they are doing.
Some of the protections are: helmets, gloves, boots, harness, etc.
ArcelorMittal Construction Page 5 of 21
Javier Cirauqui