MS-4424 Instruction Manual - Fire-Lite Alarms
MS-4424 Instruction Manual - Fire-Lite Alarms
MS-4424 Instruction Manual - Fire-Lite Alarms
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2. Installation Output Circuits<br />
Jumper Location<br />
To locate jumpers on the circuit board, see Figure 1 on page 9.<br />
GEN<br />
ALM1<br />
GEN<br />
ALM2<br />
SUPV 1<br />
Figure 10 Jumpers<br />
SUPV 2<br />
<strong>MS</strong>44-jumper.cdr<br />
Jumper Configuration<br />
The table below lists the various configurations for the NACs:<br />
If this jumper<br />
has been cut...<br />
Gen Alm #1<br />
Gen Alm #2<br />
Supv #1<br />
Supv #2<br />
Gen Alm #1 & #2<br />
and Supv #1<br />
(Ring-by-Zone)<br />
None<br />
and this<br />
Initiating<br />
Device<br />
Circuit<br />
has<br />
activated...<br />
then this<br />
Notification Appliance<br />
Circuit<br />
will be activated<br />
(x = output activated)<br />
1 2 3 4<br />
1 x<br />
2 x x x<br />
3 x x x<br />
4 x x x<br />
1 x x<br />
2 x x<br />
3 x x<br />
4 x x<br />
1 x x x<br />
2 x x x<br />
3 x x x<br />
4 x<br />
1 x x x x<br />
2 x x x x<br />
3 x x x x<br />
4<br />
1 x<br />
2 x<br />
3 x<br />
4 x<br />
1 x x x x<br />
2 x x x x<br />
3 x x x x<br />
4 x x x x<br />
Table 1 Jumper Configuration Table<br />
24 <strong>MS</strong>-<strong>4424</strong> <strong>Instruction</strong> <strong>Manual</strong> PN 15153:G1 10/22/02
Change language