DAZ-TA Pro
DAZ-TA Pro
DAZ-TA Pro
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Operating Instructions<br />
<strong>DAZ</strong>-<strong>TA</strong> <strong>Pro</strong><br />
3.2.1.1 Main menu: Joint: Edit: Joint data<br />
Activate the settings menu as described at Point 3.2.1.0 and press the SET button, then<br />
use the UP/DOWN selector keys (within the displayed min. and max. limits) to adjust the<br />
parameter as required and then press the SET button to move on to the next number.<br />
Minimum torque:<br />
TORQUE MIN:<br />
15.0 Nm<br />
Min: 2.0 Max: 25.0<br />
Maximum torque:<br />
TORQUE MAX:<br />
25.0 Nm<br />
Min: 15.0 Max: 220.0<br />
Snug point:<br />
SNUG POINT DFF:<br />
15.0 Nm<br />
Min: 2.0 Max: 25.0<br />
Minimum angle:<br />
MIN ANGLE:<br />
25°<br />
Min: 2.0 Max: 35<br />
Maximum angle:<br />
MAX ANGLE:<br />
35°<br />
Min: 25 Max: 1200<br />
Direction of rotation/direction of tightening:<br />
sequences)<br />
Direction of rotation:<br />
Anticlockwise<br />
clockwise<br />
Measuring mode:<br />
Priority: (for processing<br />
Priority:<br />
Low ’ # ’<br />
High ’ * ’<br />
Detection of existing joint:<br />
Measuring mode:<br />
yield point (YP)<br />
Angle/torque<br />
Torque<br />
PREANGLE MEAS.<br />
5°<br />
Min: 1 Max: 15<br />
See Point 3.2.2.0<br />
M0 Angle/torque: Torque/angle-controlled measurement<br />
M1 Torque:<br />
Torque measurement<br />
M2 Track: Free measurement, 25 values /s<br />
M3 Prevail torque: Measuring prevail torque<br />
M4 Loosen:<br />
Torque measurement at lowest value<br />
M5 Either Or:<br />
Torque and/or angle measurement<br />
M6 Yield point:<br />
Yield strength detection<br />
Change level: 02/07 Version<br />
8000.15.2<br />
.<br />
Refer to lower figure: If the snug point is reached within<br />
the preangle (e.g. 5°), the wrench will show "Existing<br />
joint" (DDT)<br />
(Joint Not OK).<br />
Page: 15 / 56
Change language