DAZ-TA Pro

More documents

Recommendations

Info

Operating Instructions DAZ-TA Pro 1.3 Display Standard display 1.4 Functions of the LEDs Snug point reached in torque/angle (N) measuring mode Torque: (blue) snug point reached Angle: (off) not yet reached Preset reached (OK) in torque/angle (N) measuring mode Torque: (green) OK Angle: (green) OK Torque exceeded (not OK) in torque/angle (N) measuring mode Torque: (red) Not OK Angle: (green) OK Torque and angle exceeded (not OK) in torque/angle (N) measuring mode Torque: (red) Not OK Angle: (red) Not OK Change level: 02/07 Version 8000.15.2 Page: 6 / 56
Operating Instructions DAZ-TA Pro NOK Nm Max Nm Deviation Target Nm = (Max Nm +Min Nm)/2 OK Min Nm advance warning Nm = 80% Set Nm LED Nm snug point 0° snug point advance warning Nm = 80% Set Nm Min ° Target ° = (Max ° +Min °)/2 Max ° LED ° OK NOK TORQUE LED Nm: Upper LED flashes blue: Upper LED shows steady blue: Upper LED flashes green: Upper LED shows steady green: Upper LED shows steady red: TIGHTENING ANGLE LED°: Lower LED flashes blue: Lower LED shows steady blue: Lower LED flashes green: Lower LED shows steady green: Lower LED shows steady red: Snug point reached Advance warning point attained Min. torque attained (OK) Preset torque attained (OK) Max. torque attained (Not OK) Snug point attained (start angle measurement) Advance angle warning point attained Min. angle attained (OK) Preset angle attained (OK) Max. angle attained (Not OK) Change level: 02/07 Version 8000.15.2 Page: 7 / 56
Page 1 and 2: Operating Instructions DAZ-TA Pro E
Page 3 and 4: Operating Instructions DAZ-TA Pro 3
Page 5: Operating Instructions DAZ-TA Pro 1
Page 19 and 20: Operating Instructions DAZ-TA Pro E
Page 39 and 40: Operating Instructions DAZ-TA Pro N
Page 45 and 46: Operating Instructions DAZ-TA Pro X
Page 49 and 50: Operating Instructions DAZ-TA Pro I
Page 53 and 54: Operating Instructions DAZ-TA Pro C
Page 55 and 56: Operating Instructions DAZ-TA Pro S

DAZ-TA Pro

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?