group 18 Trim, Seats and Convertible Top.pdf

More documents

Recommendations

Info

~ ~ ~ ~ .- " z w .- z ~ , ~ ~ ~ ~ ~ ~ Q ~ ~ ~ , ~ ~ .. ~ ~ " ~ OW Zow" OJ ..., ~W ~o- ~~ o.:r 00- oj" >% ~§ ~ ~'" ~w 0-- z< w~ ~~ :) 0 ~ 0> c: "+:: 0 v 0 -J ~ 0 a)
PART 18-3-Convertible Top 18-47 rear curtain and compartment trim lIlaterials. b. Mark the rear curtain along the lower edge of the belt center tacking strip (Fig. 13, View BB and CC). c. Mark the belt center tacking strip to indicate the rear window opening at both sides (Fig. 13, View BB). d. Mark the top deck quarters along the lower edge and at the ends of each belt side front tacking strip (Fig. 13, View CC). 20. Carefully and without tearing the material, detach the trim material being replaced from the tacking strips. 21. Trim off the selvage edge of the old top deck quarter and/or back curtain material that extends below the tacking strips. The selvage edge must only be cut from the old parts which are being replaced. Installation 1. Lay the new rear curtain window assembly on a clean bench with the interior surface up. Measure the width and mark the center of the back window at the top, above the zipper, and at the bottom, at the tacking strip area (Fig. 13). 2. Using the old rear curtain window assembly as a template, mark the new curtain to indicate the lower edge of the tacking strip. Also mark the tacking strip attaching hole locations. Carefully remove the old rear curtain window assembly and cut out the tacking strip attaching holes in the new curtain, only. 3. Using the old top assembly as a template, mark the new top quarter deck to indicate the lower edge of the tacking strip. Also mark the tacking strip attaching hole locations. Discard the old top. Cut out the tacking strip holes in each quarter of the new top, only. Do not trim off the sel~age edge. 4. Using the old compartment trim as a template, transpose the markings to the new compartment. 5. Align the belt center tacking strip with the compartment trim alignment marks and retain with staples. The edge of the material should be flush with the bottom of the tacking strip. 6. Align the belt center tacking strip with the rear curtain window aligning marks and retain it with staples. 7. Align the belt side front tacking strip with the aligning marks on the top deck quarter (both sides) and retain it with staples. 8. Position each top back stay webbing on the belt center tacking strip and retain it with staples (Fig. 14). 9. Align the top deck quarter to the belt center tacking strip. maintain proper rear curtain opening and retain it with staples (Fig. 13, View BB). 10. Carefully position the upper half of the zipper assembly on the No.4 bow aligning the bow and material center marks. The edge of the material should be flush with the front edge of the No.4 bow tacking strip. Working from the center outboard, secure the assembly with staples. Both ends of the elastic strip should correspond with the marks on the No.4 bow. Refer to Step 19 under Removal. 11. Position the rear curtain and top assembly on the stack and engage the zipper. 12. Position the top back stay webbing on the No.4 bow aligning marks and secure it with staples (Fig. 14). 13. Install a piece of masking tape on the underside of the No.4 bow at the centerline punch mark located
Page 1: PART 18-1 PAG E Interior Trim And R
Page 4 and 5: 1352-A FIG. 5. Typical Door Trim Pa
Page 6 and 7: 18-6 GROUP l8-Trim, Seats, And Conv
Page 8 and 9: 18-8 GROUP l8-Trim, Seats, And Conv
Page 10 and 11: 18-10 GROUP la-Trim, Seats, And Con
Page 12 and 13: F () - :~ ;: 18-12 GROUP l8-Trim, S
Page 14 and 15: 18-14 GROUP 18-Trim, Seats, And Con
Page 16 and 17: 18-16 GROUP l8-Trim, Seats, And Con
Page 18 and 19: 18-18 GROUP l8-Trim, Seats, And Con
Page 20 and 21: 18~20 GROUP l8-Trim, Seats, And Con
Page 22 and 23: turnbuckle or eye bolt enough turns
Page 24: 18-24 GROUP l8-Trim, Seats, And Con
Page 27 and 28: PART 18-2-Seats 1 8-27 9. Sec.ure t
Page 29 and 30: PART 18-2-Seats 18-29 A C \ JUTE BO
Page 31 and 32: the retaining screws. Also install
Page 33 and 34: PART 18-2-Seats 18-33 FIG. 16-Front
Page 35 and 36: 21 Care of Top Fabric , 3 Adjustmen
Page 37 and 38: PART 18-3-Convertible Top 1 8-37 )/
Page 39 and 40: PART 18-3-Convertible Top 18-39 obt
Page 41 and 42: ~ PART 18-3-Convertible Top 18-4 RO
Page 43 and 44: PART 18-3-Convertible Top 18-43 the
Page 45: ~ ~ m M -0 '" ~ il \\\tf) :\/ u \\\
Page 49 and 50: ~ PART 18-3-Convertible Top 18-49 4
Page 51: PART 18-3-Convertible Top 1 8-5 1 T

group 18 Trim, Seats and Convertible Top.pdf

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?