Freedom SW 3000 Sine Wave Inverter/Charger - Xantrex

UL 458
Front and Side Panels
Before you begin to operate the Freedom SW 3000, review the front panel
features shown in Figure 3 and described in the next table. A detailed view
of the lights and buttons on the front panel is shown in Figure 4 and
described in the table next to it.
3
FREEDOM SW 3000
3000W SINEWAVE INVERTER/CHARGER
30 3614
CSA 107.1-01
Model
Number
FGA
Number
FSW3000
815-3000
Inverter Mode:
Nominal DC Operating Voltage: 12 Vdc
Nominal AC Output Voltage: 120 Vac , 1Ø
Nominal AC Output Frequency: 60 Hz
Max. Continuous AC Output Cu rent: 25 A
Max. Operating DC Input Cu rent: 320 A
Max. Continuous AC Output at Nominal DC
Input: 3000 VA at 25°C
Max. Output Surge Power (5 s duration): 6000 VA
Max. DC Input Voltage: 16 Vdc
Max. Ambient Temperature: 50°C
Nominal AC Input Voltage: 120 Vac , 60 Hz, 1Ø
Power Factor: > 0.95
Charging DC Output Voltage Range: 5.0 - 16.0 Vdc
Max. Continuous Ba tery Charger DC Cu rent at
Nominal AC Input: 150 A
Max. AC Input Cu rent: 30 A per line Split Phase,
30 A per line Dual
Charger Mode:
Serial Number
FREEDOM SW 3000
Xanbus Interface
Inverter
Reset Enable Inverter AC/
On Charge Fault
FREEDOM SW 3000
1
Item
Description
Freedom SW 3000 Inverter/Charger Features
1 Front Panel contains the Xanbus interface ports for
connecting Xanbus-enabled devices, the Inverter Enable
and Reset buttons, as well as various LED status lights.
See Figure 4.
2 Mounting holes are used for mounting the unit. A total of
eight holes are provided on the unit.
3 Two variable-speed cooling fans are used to cool the
unit. Fan speed control is based on internal temperature of
critical components. The two exhaust fans control airflow
though the transformer and power compartments of the
unit. Ensure at least six inches of clearance for proper
ventilation.
INSTALLATION REQUIREMENTS:
Moun this inverter/charger only in the orientations
specified in the insta lation guide provided.
CAUTION: To reduce the risk o fire, do not
Designed in Canada
A sembled in China
cover or obstruct ventilation openings. Do not mount
in a zero-clearance compartment. Overheating may
result. Do not expose to rain or spray.
WARNING: Shock hazard. Do not open. No
user serviceable parts. Energized from both AC and
DC sources. Disconnect a l sources before servicing.
Use only ground-fault circuit inte rupters (GFCI)
specified in the insta lation guide supplied. Other
Date of Manufacture
types may fail to operate properly when connected to
this equipment. Refer to manual. Charge only
lead-acid ba teries. Other ba tery types may burst
causing personal injury and damage.
DANGER: To reduce the risk of explosion, do not
insta l in an area in which ignition-protected
euipment is required.
2
Figure 3 Isometric View of the Front Panel and Fans
975-0545-01-01 7