Internet Communications Module 7845i - Patriot Alarm Systems, Inc.

Internet Communications Module 7845i Installation and Setup Guide
ECP Status Codes
The 7845i sends status messages to the control panel for tamper and network
communication failures. When using ADEMCO’s low-end control panels (VISTA-10SE,
VISTA-20SE, VIA-30P, the status is displayed on the control panel’s keypad as “Long Rnge
Fail” followed by a 4-digit code). These codes are listed in Table 4, as well as Contact ID
codes (listed in Table 5) that are sent to the central station.
STATUS CODE
Table 4. ECP Keypad Displays Status Codes
DESCRIPTION
0000 Control panel lost communication with 7845i
0880 7845i tamper detected (cover removed)
0005 7845i has lost contact with AlarmNet
000F
7845i is not registered; radio account not activated
0400 7845i Power On Reset.
0C80
0C8F
CODE*
R330 C8xx**
E339 C8xx**
E341 C8xx**
R341 C8xx**
E355 C000
R355 C000
7845i Power On Reset & Tamper detected
7845i Power On Reset & Tamper detected & Not Registered
Table 5. ECP Contact ID (685 Displays) Codes
DESCRIPTION
Restore of RF faults (restore of peripheral trouble)
ECP power-on reset
ECP tamper
ECP tamper restore
* As displayed on 685 Digital Receiver.
** xx = 7845i device address.
Radio lost communication with control panel
Radio restore communication with control panel
4-10
Technical Manuals Online! - http://www.tech-man.com