Internet Communications Module 7845i - Patriot Alarm Systems, Inc.

More documents

Recommendations

Info

Internet Communications Module 7845i Installation and Setup Guide 1 2 3 4 5 6 7 8 9 TX, green Message Status, yellow Fault, red Internet Link, yellow Interactive Registration 1. Unregistered, normal operation 2. Registration message pending 3. Registration message transmitted 4. Registration accepted by AlarmNet 5. Registered, normal operation 6. Power-on reset message pending 7. Power-on reset message transmitted 8. Power-on reset message acknowledged by AlarmNet 9. Normal operation Once the registration has been completed successfully, the 7845i enters normal operating mode; the TX (green) LED goes out and the Message Status (yellow) LED is lit to indicate that the power-on / reset message is waiting to be sent. If registration is not validated within 30 seconds, the 7845i times out. If repeated registration attempts time out, check your Internet connection and verify that 7845i account information has been entered correctly. The interactive registration feature allows the installer to register the 7845i through a series of keyboard commands on the 7720P Programming Tool. This method of registration lets the installer monitor the registration process. Registering … Registration SUCCESS Once the installation is complete, press the [↑] key on the 7720P. The registration message is sent and the unit waits for the acknowledgment. If this is a new installation and the city, central station, and customer numbers have been correctly entered, the 7845i is registered and this message is displayed. At this point, the 7845i is in full service and available for alarm reporting to the central station. 5-2 Technical Manuals Online! - http://www.tech-man.com
Section 5: Registration Possible Errors Registration BAD Timed Out Registration BAD Pri Sub ID BAD Registration BAD 2nd Sub ID BAD Registration BAD Pri&2nd IDs BAD Registration BAD Pri ID – Need PIN Registration BAD 2nd ID – Need PIN Registration BAD Pri&2nd – Need PIN If no response to the registration request is received from AlarmNet, this message is displayed. The city, central station, or customer number for the Primary account is not accepted. The ID information was either entered in error, or the central station failed to pre-authorize programmed ID numbers with AlarmNet customer service. The city, central station, or customer number for the Secondary account is not accepted. The ID information was either entered in error, or the central station failed to pre-authorize programmed ID numbers with AlarmNet customer service. The city, central station, or customer number for BOTH the Primary and Secondary accounts are not accepted. The ID information was either entered in error, or the central station failed to pre-authorize programmed ID numbers with AlarmNet customer service. This prompt is displayed if this is a repair/replacement, or an error was made in programming the Primary account information of 7845i for an existing account. This prompt appears for two seconds. See the 7845i Replacement section below for further displays. This prompt is displayed if this is a repair/replacement, or an error was made in programming the Secondary account information of 7845i for an existing account. This prompt appears for two seconds. See the 7845i Replacement section below for further displays. This prompt is displayed if this is a repair/replacement, or an error was made in programming the BOTH the Primary and Secondary account information of 7845i for an existing account. This prompt appears for two seconds. See the 7845i Replacement section below for further displays. 7845i Replacement Enter PIN now? Y/N PIN: Registering … At this point, you should have called call the AlarmNet Technical Assistance Center (TAC) to obtain a 4-digit alphanumeric PIN number. Pressing [Y] continues the registration process. If you pressed [Y] the next prompt is displayed. Pressing [N] aborts the process. You must enter a 4-digit alphanumeric PIN number obtained by an authorized person's phone call to the AlarmNet TAC (Technical Assistance Center). Enter the PIN, then press the [Enter] key. The registration message is sent and the unit waits for acknowledgement. Technical Manuals Online! - http://www.tech-man.com 5-3
Page 1 and 2: Internet Communications Module 7845
Page 3 and 4: Table of Contents • • • •
Page 5 and 6: S E C T I O N 1 General Information
Page 7 and 8: + + + S E C T I O N 2 Mounting and
Page 9 and 10: S E C T I O N 3 Communications Setu
Page 11 and 12: Section 3: Communications Setup to
Page 13 and 14: S E C T I O N 4 Programming AlarmNe
Page 15 and 16: Using a 7720P Programming Tool Sect
Page 17 and 18: Section 4: Programming AlarmNet-i a
Page 25: S E C T I O N 5 Registration •
Page 29 and 30: S E C T I O N 6 Summary of 7845i LE
Page 31 and 32: Message Status During Normal (Idle)
Page 33 and 34: Section 6: Summary of 7845i LED Ope
Page 35 and 36: S E C T I O N 7 Programmer Keyboard
Page 37 and 38: S E C T I O N 8 Getting Code Update
Page 39 and 40: S E C T I O N 9 Specifications •
Page 41 and 42: S E C T I O N 1 0 Glossary • •
Page 43 and 44: ADEMCO LIMITED WARRANTY Alarm Devic

Internet Communications Module 7845i - Patriot Alarm Systems, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?