COLDLAM/HOTLAM TH 1100N/1600N/2000N Mounter ... - Neschen

2.3 Machine description
2.3.1 General
The machine is designed for laminating pressure or heat
sensitive materials. Two silicone-coated rollers generate this
pressure while feeding through images and the films.
For the upper main roller an optional heater is available that
enables the machine to process also heat sensitive films.
The machine can be divided in an upper and a lower section.
The upper section consists of 2 auto-grip shafts and a splitting
bar (idler).
One shaft is for unwinding film, the other for re-winding the
release liner. Optional an additional top unwind shaft can be
installed.
The 2 auto-grip shafts in the lower section are also optional.
When this option is installed, this section is the mirror image of
the upper section.
The area where the upper and lower main roller meet is called
the “nip”. The upper main roller can be moved up or down, so
the nip can be varied to feed materials of various thicknesses.
The lower main roller is motor driven. The speed can be
manually set between zero and a given maximum value.
When the rollers are equipped with a heater, the temperature
of the roller-surface is controlled by the heater controls
installed just above the control panel.
2.3.2 Parts recognition
In this machine the following parts can be recognized:
Figure 3: Main parts identification.
1 Lower main roller 10 Control panel
2 In-feed table 11 Splitting bar
3 Image guide/
Input nip safety bar
4 Upper main roller
5 Auto-grip shaft
6 Wind-up tension control
7 Emergency button
12 Output nip safety bar
(finger protection)
13 Output table with cutting
groove or support table
14 Nip setting and pressure
control wheel
8 Unwind tension control 15 Foot switch
9 Heater control 16 Identification label
Description 9
English