COLDLAM/HOTLAM TH 1100N/1600N/2000N Mounter ... - Neschen

5 MAINTENANCE
Service activities on this machine must be carried out by
qualified personnel.
5.1 Cleaning
The machine has to be cleaned regularly. Dirt and dust may
influence the result of the lamination processes.
CAUTION:
Do not use abrasive materials for cleaning the
machine. This can damage the painted surfaces or
the silicone covering of the rollers.
Use a damp cloth for cleaning.
CAUTION:
Make sure water does not run into any of the
cabinets. This can damage the electrical circuits
when power is applied.
Clean the exterior of the machine with a damp cloth as
needed. If necessary, use a household-cleaning solution to
remove difficult marks.
Clean the shafts and the rubber cords on it as required.
5.1.1 Cleaning the silicone covered rollers.
The rollers must be cleaned regularly to prevent a build-up of
adhesive residue. This may eventually damage the rollers.
Use a damp lint-free cloth to remove dust and other dirt.
Use a silicone-cleaning block to remove the adhesive stains
from the rollers.
Note:
Adhesive is easier to remove when the rollers are hot.
Put a waste panel between the rollers when cleaning the
upper roller, to prevent adhesive residues from falling onto the
lower roller.
WARNING:
MAKE SURE THE ROLLERS ARE COLD
WHEN USING ALCOHOL FOR CLEANING.
ISOPROPYL ALCOHOL IS EASY
FLAMMABLE.
Difficult stains can be removed with isopropyl alcohol (IPA) on
a clean lint-free cloth.
Do not pour isopropyl alcohol directly on the machine.
Maintenance 29
English