Series 15i-A Maintenance Mnl, GFZ-63325EN/03 - Automation ...

1. SCREEN INDICATIONS AND OPERATIONS B–63325EN/03
TYPE 3: Traces data for the specified time period until the specified
trigger event occurs after the [TRACE] soft key is pressed.
[TRACE] key pressed
Tracing period
Event occurs
Time
TRIGGER EVENT
Set a trigger event for the type–2 or type–3 tracing condition.
In the type–2 tracing condition, when the specified trigger event occurs,
tracing starts. In the type–3 tracing condition, tracing ends when the
specified trigger event occurs.
SERVO ALARM
Specify whether a servo alarm serves as a trigger event.
VALID: A servo alarm serves as a trigger event.
INVALID: A servo alarm does not serve as a trigger event.
DI/DO SIGNAL
Specify whether the specified machine signal serves as a trigger event.
ON: An ON transition of the specified machine signal serves as a
trigger event.
OFF: An OFF transition of the specified machine signal serves as a
trigger event.
CHANGE: A change of the specified machine signal serves as a
trigger event.
INVALID: A machine signal does not serve as a trigger event.
DI/DO SIGNAL ADDRESS
Set the address of the machine signal when the machine–signal setting
above is ON, OFF, or CHANGE.
TRACE TIME
Set the data tracing period in a range of 10 ms to 80000 ms.
A tracing cycle is determined according to the tracing period as shown
below.
Tracing cycle
Tracing period
Servo–related items,
combined speed, and
spindle–related items
Machine signal
10 to 10000ms 2ms 8ms
to 20000ms 4ms 8ms
to 40000ms 8ms 8ms
to 80000ms 16ms 16ms
28