Series 15i-A Maintenance Mnl, GFZ-63325EN/03 - Automation ...

1. SCREEN INDICATIONS AND OPERATIONS B–63325EN/03
TRACE DATA TYPE
Specify the number of the data to be traced.
Data number Type Unit
0 No tracing
1 Servo position error Pulse (detection unit)
2 Servo pulse count after distribution Pulse (detection unit)
3 Servo torque %
4 Servo pulse count after acceleration and
deceleration
Pulse (detection unit)
5 Servo actual speed Pulse (detection unit)
6 Specified servo current %
7 Thermal–simulation data of servo %
8 Combined speed for all axes MM/MIN,INCH/MIN,RPM
9 Spindle speed min –1
10 Spindle load meter %
NOTE
1 The combined speed for all axes does not include the speed
along the axis which is excluded by the DI signal *ACTF for
axis selection in actual speed indications.
2 The servo torque and the specified servo current are
indicated in percentage (%) of the parameter values (No.
1979)
AXIS ASSIGN
Specify an axis number according to the type of the data to be traced, as
shown below.
Data number Type Axis number
1 Servo position error Servo axis number (1 or
greater)
2 Servo pulse count after distribution
3 Servo torque
4 Servo pulse count after acceleration and
deceleration
5 Servo actual speed
6 Specified servo current
7 Thermal–simulation data of servo
8 Combined speed for all axes Head number (1 or greater),
specify in TT series
9 Spindle speed Spindle number (1 or
greater)
10 Spindle load meter
30