Download Lab Safety Manual - Integrated Nanosystems Research ...

More documents

Recommendations

Info

Solid Solvent Waste The steel waste containers are designated for solid waste. These are usually red or yellow and identified with flammable or solvent waste only labels. Use for clean room wipes, foil paper exposed to solvent material. If material is saturated please use individual trash bags before disposing into the waste container. Always make sure the container lid is completely closed when finished. Solid Acid Waste The plastic white containers are for solid acid waste only. Clean up wipe exposed to acid, any saturated item used to clean up small acid spills on bench tops or from extensive cleaning. Put in double containment bags before disposing of them. Make sure the lid in completely closed when finished. Check with staff if any questions. 64
Nitrile <strong>Safety</strong> Gloves These are general use nitrile gloves. They are located in the gowning area and are required To be worn as a first level protection. If you are allergic to nitrile please notify staff. Masks The facility provides a general use particulate mask. It does not protect the user from Hazardous materials. The mask is to prevent particulate material from contaminating the device you are working on. Other masks are available. Check with staff for proper use and availability. 65
Page 2 and 3:
Table of Contents 1 Safety Philosop
Page 4 and 5:
9.8 Odors in the lab:…………
Page 6 and 7:
The staff at INRF/BiON also recogni
Page 8 and 9:
• Gas Hazards Compressed gases po
Page 10 and 11:
physical and chemical properties, t
Page 12 and 13:
5.2 Liquid Chemical Storage To prev
Page 14 and 15: ‣ Protective Gear (PPE) Protectiv
Page 16 and 17: Antimony, Arsenic, Barium, Berylliu
Page 18 and 19: ‣ Other Oxidizing Acids Nitric, a
Page 20 and 21: 8 Specific Hazardous Gases 8.1 Pyro
Page 22 and 23: 9.2 Building and lab Evacuations Al
Page 24 and 25: Chemical spills that occur outside
Page 26 and 27: * Response Procedures 1. In the eve
Page 28 and 29: 10. Alarms 10.1 Fire Alarms Appeara
Page 30 and 31: 11.4 INRF Laboratory Safety Map Int
Page 32 and 33: Building Number 321 is the INRF lab
Page 34 and 35: • Outside of the bottle is clean
Page 36 and 37: How to dispose of corrosive and oth
Page 38 and 39: I. ACIDS Characteristics • Typica
Page 40 and 41: Personal Protection • Be sure tha
Page 42 and 43: IV. SOLVENTS Characteristics • Ma
Page 44 and 45: Immediate Action Personal Protectio
Page 46 and 47: Common Toxics: Solids Antimony Comp
Page 48 and 49: VIII. PYROPHORIC SUBSTANCES Charact
Page 50 and 51: Liquid helium 700 to 1 Liquid nitro
Page 52 and 53: XII. TOXIC GASES Characteristics
Page 54 and 55: XIII. REACTIVE OR EXPLOSIVE CHEMICA
Page 56 and 57: XIV. CARCINOGENS Characteristics
Page 58 and 59: XV. CDC SELECT AGENTS, USDA HIGH CO
Page 60 and 61: Bacillus anthracis Brucella abortus
Page 62 and 63: Personal Chemical Storage Personal
Page 66 and 67: Sharpie Container Sharpie container
Page 72 and 73: Chemical Utensil & Hot Plates Some
Page 74 and 75: “ Solvent” Wet Bench Solvent be
Page 76 and 77: Eye Wash on “ Standard “ Wet Be
Page 78 and 79: Transporting Chemical Bottle When t
Page 80 and 81: Gas Detection System For Combustibl
Page 82 and 83: Inches of water Exhaust Alarm These
Page 84 and 85: Pollution Control Device INRF This
Page 86 and 87: Procedures / Steps Needed To Comple
Page 88 and 89: E. Dispose the HF/Silicone oil wast
Page 90 and 91: #3 Engineering Controls: Describe a
Page 92 and 93: #9 Decontamination and spill clean-
Page 95: SAFETY COMPLIANCE FORM THIS FORM MU
show all

Download Lab Safety Manual - Integrated Nanosystems Research ...

Create successful ePaper yourself

Delete template?

Save as template?