Download Lab Safety Manual - Integrated Nanosystems Research ...

More documents

Recommendations

Info

Gas Detection System For Combustibles This is one of our combustible gas detection systems. This system detects Hydrogen and Methane. It is located in the oxidation furnace area. Once these gases are detected the light indicators will go red and an audible alarm will sound. Evacuate area and notify staff. Emergency off For Reactive gas and Power These are EPO (emergency off switch). The larger one will shut down combustible and reactive gases. The smaller one labeled AC emergency off switch will shut down all the utility power is that adjacent room. These switched are designated for that adjacent area. Other emergency switches are located throughout the lab. 80
Combustible Gas in Use in Room These signs are above the doors that combustible and reactive gases are being used. This is a visual notice so users know combustible gases are in use. Exhaust Alarm for Laminar Flow Bench There are visual and audible alarms for different types of exhaust hoods. This type is located on the standard wet benches. There are other types for the solvent benches, dedicated benches and fume hoods. Be familiar with their location and operation of these alarms. 81
Page 2 and 3:
Table of Contents 1 Safety Philosop
Page 4 and 5:
9.8 Odors in the lab:…………
Page 6 and 7:
The staff at INRF/BiON also recogni
Page 8 and 9:
• Gas Hazards Compressed gases po
Page 10 and 11:
physical and chemical properties, t
Page 12 and 13:
5.2 Liquid Chemical Storage To prev
Page 14 and 15:
‣ Protective Gear (PPE) Protectiv
Page 16 and 17:
Antimony, Arsenic, Barium, Berylliu
Page 18 and 19:
‣ Other Oxidizing Acids Nitric, a
Page 20 and 21:
8 Specific Hazardous Gases 8.1 Pyro
Page 22 and 23:
9.2 Building and lab Evacuations Al
Page 24 and 25:
Chemical spills that occur outside
Page 26 and 27:
* Response Procedures 1. In the eve
Page 28 and 29:
10. Alarms 10.1 Fire Alarms Appeara
Page 30 and 31: 11.4 INRF Laboratory Safety Map Int
Page 32 and 33: Building Number 321 is the INRF lab
Page 34 and 35: • Outside of the bottle is clean
Page 36 and 37: How to dispose of corrosive and oth
Page 38 and 39: I. ACIDS Characteristics • Typica
Page 40 and 41: Personal Protection • Be sure tha
Page 42 and 43: IV. SOLVENTS Characteristics • Ma
Page 44 and 45: Immediate Action Personal Protectio
Page 46 and 47: Common Toxics: Solids Antimony Comp
Page 48 and 49: VIII. PYROPHORIC SUBSTANCES Charact
Page 50 and 51: Liquid helium 700 to 1 Liquid nitro
Page 52 and 53: XII. TOXIC GASES Characteristics
Page 54 and 55: XIII. REACTIVE OR EXPLOSIVE CHEMICA
Page 56 and 57: XIV. CARCINOGENS Characteristics
Page 58 and 59: XV. CDC SELECT AGENTS, USDA HIGH CO
Page 60 and 61: Bacillus anthracis Brucella abortus
Page 62 and 63: Personal Chemical Storage Personal
Page 64 and 65: Solid Solvent Waste The steel waste
Page 66 and 67: Sharpie Container Sharpie container
Page 72 and 73: Chemical Utensil & Hot Plates Some
Page 74 and 75: “ Solvent” Wet Bench Solvent be
Page 76 and 77: Eye Wash on “ Standard “ Wet Be
Page 78 and 79: Transporting Chemical Bottle When t
Page 82 and 83: Inches of water Exhaust Alarm These
Page 84 and 85: Pollution Control Device INRF This
Page 86 and 87: Procedures / Steps Needed To Comple
Page 88 and 89: E. Dispose the HF/Silicone oil wast
Page 90 and 91: #3 Engineering Controls: Describe a
Page 92 and 93: #9 Decontamination and spill clean-
Page 95: SAFETY COMPLIANCE FORM THIS FORM MU
show all

Download Lab Safety Manual - Integrated Nanosystems Research ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?