READ THIS MANUAL CAREFULLY! - Mojo Motorcycles

6. Install the filler bolt and tighten to the specified torque.
Filler bolt (rear gear case) tightening torque: 23 N m (2.3 m kgf, 16 ft lbf)
7. Check for oil leakage. If oil leakage is found, check for the cause.
Be sure no foreign material enters the rear gear case.
1. Place the machine on a level place.
2. Remove the oil filler bolt and check the oil level. It should be
up to the brim of the hole. If the level is low, add sufficient oil
to raise it to the specified level.
3. Install the oil filler bolt and tighten it to the specified torque.
Oil filler bolt tightening torque: 2 3 Nm (2.3 m kgf, 16 ft lbf)
1. Place the machine on a level place.
2. Place a container under the front gear case to catch the oil.
3. Remove the filler bolt and drain bolt to drain the oil.