domus - the complete solution - CMS

FIREBRAKE● Meets the requirements of Approved Document Bof the UK Building Regulations● Meets the requirements of NHBC Standard(April 2004) 8.1-S2 (f)● Tested by BRE to BS 476 Part 20:1987 and prEN 1366-3● 2 hour fire rating● Available for all five sizes of Domus flat channelducting systems48The Domus FireBrake is a unique, scientificallyadvanced intumescent product to prevent thespread of fire through plastic ventilation ductingsystems. It has been designed specifically for itsintended purpose.Fire prevention is a serious concern. BuildingRegulations state that when a compartment wallis penetrated an approved fire-stopping deviceshould be installed. The purpose is to containfire spread that could be harmful to life, and tomaintain the integrity of the building for as longas possible.FireBrake reacts to the heat from the fire andexpands inwards stopping the spread of the fireby quickly providing a 100% closed fire stopseal.FireBrake has been designed with safety of thehouseholder as its primary concern. This givesthe installer unparalleled peace of mind that theinstallation is fit for purpose and will passinspection by Building Control.FireBrake allows simple but effective installationto deal with most common problems faced onsite which often make alternative options likefire collars and wraps unsuitable.Due to its construction, design features, anduser friendly nature you can specify and installFireBrake with confidence.FireBrake is available for all five sizes of Domusflat channel ducting systems.Quick and easy installationDomus FireBrake is very simple to install.Its user friendly nature avoidsimprovisation during fitting particularlyin areas that are difficult to access.This is a significant advantage over wrapsand collars.FireBrake ensures professionalinstallation. It is the correct fire stop for allDomus rectangular ventilation ducting.In most fire-stopping applications twocollars or wraps are required, one oneither side. Thus FireBrake can providesubstantial cost savings, especiallyin installation time. No maintenanceis required.For masonry or stud walls andconcrete floorsDomus FireBrake is designed for multipurposeinstallation. For stud walls thesteel casing (fitted as standard) ensuresthat the product closes inwards. The125mm length of FireBrake is sufficient toprevent it falling through a stud wall oncethe duct has melted away. This is not thecase with most collars. Wraps are notsuitable for use within stud walls.Robust ConstructionDomus FireBrake is strong enough to copewith the rigours of transportation and thehazardous environment on building sites.Its sturdy nature inspires confidence that itwill be fit for purpose.No additional fixings necessaryThe Domus FireBrake does not requireadditional fixings, such as screws andmetal anchors. This saves considerabletime and money on site.Forms an integral part of theducting systemDomus FireBrake acts as a connector.It can be incorporated as part of theducting system design providing aseamless configuration.Designed to put safety firstDomus FireBrake helps prevent carelessinstallation. This is a common problemwith wraps and collars as they are difficultto work with. Careless installation canresult in failure under fire conditions.