1633 Combustion Controller Manual - Novatech Controls

All wiring should comply with local electrical codes. The printed circuit boards are fully floating above earth. Allearth and shield connections should be connected to the earth stud on the LHS inside the case. Before connection ofmains power check that the 115 / 230 volt power selector switch is set to the correct voltage.Burner safety lock,or if safety interlocknot required, linkterminals 18 & 194-20mA OutputsSelectablerangesRedOptional AlarmRelay ContactsNormally ClosedOrangeBlackLinear actuator fortrim control.4-20 mA InputLinear actuator fortrim control.Motor Inc/Dec12345678 TC I/P+9 TC I/P-10 Probe #2+11 Probe #2-12 Purge Flow13 Purge Flow14 Fuel 1/215 Fuel 1/216171819Probe +Probe -Probe TC+Probe TC-Probe TC2/Aux+Probe TC2/Aux-+12VRemote AlarmRemote AlarmBurner On InputBurner On Input20 RS-232 Rx21 RS-232 Tx22 Network -232425 Output 1+Network +Serial Common26 Output 1-27 Output 2+28 Output 2-29 Common Alarm30 Common Alarm31 Alarm 232 Alarm 233 Alarm 334 Alarm 335 Alarm 436 Alarm 4Mains Power240/115VAC41 Purge/Cal Sol42 Purge/Cal Sol43 Motor Inc44 Motor Inc45 Motor Dec46 Motor Dec47 Mains E4849 Mains N50 Mains A51 Heater #152 Heater #153 Heater #254 Heater #2Oxygen ProbeBurner feedbacktransmitter55 BFT Power56 BFT Signal57 BFT CommConnection Diagram for 1633 Analyser and a 1232 Unheated ProbeAugust 200924 1633 Combustion Controller