General Catalogue 2007 - Ibemo Kazakhstan Ltd

Technical characteristics
Dimmers
The Tebis dimming offer includes :
• Dimmers with direct output 300, 600 or 1000 W
• Pilots with 1 or 3 outputs
Dimmers with direct output
Completely renewed, this extended range integrates the new design
and the quick connect.
It includes the following products :
• TXA 213 : 3 outputs 300 W
• TXA 210 : 1 output 600 W
• TXA 215 : 1 output 1000 W
• TXA210A : 1 output 300W
These products allow the direct connection of the incandescent
LV or ELV halogen loads. They adapt automatically with the type of
connected load and have an integrated overheating and overload
protection.
Other advantages
• Manual control even when bus is disconnected.
• Mini/maxi level local setting
• Memorizing up to 8 different scene levels of lighting.
• Call of present level by priority setting
Dimmers
Technical characteristics
TXA210A TXA210 TXA213 TXA215 TXA211/TX214
Number of outputs 1 output 300W 1 output 600W 1 to 3 output according
to selector
1 output 1000W 1 or 3 outputs 1-10V
Dimming range in 25 to 600W / 600VA 20 to 300W / 300VA 20 to 1000W / VA Output 1-10V : Current
230V or in VLV 20 to 600W / 600VA max. 50mA + contact
ferromagnetic or
electronic transformer
20 to 900W / 900VA TOR 16A AC1
Supply 30V DC + 230V - 50/60Hz
Max; dissipation of
the product
4W 7.5W 9W 10W 9W
Working temperature 0 to +45ºC -20 to +70ºC
Storage temperature -20 to +60ºC -20 to +60ºC
Degree of protection IP30
Width of module 1 6 4
Connection 0.75 to 2.5� with flexible or rigid wire quick connect terminal Flexible: 1 to 6�
� � � � � Rigid: 1.5 to 10�
Hager Catalogue 2007 • Technical
Pilot dimmers 1-10 V : TX 211, TX 214
The modules TX 211 and TX 214 are provided for control by output :
• Up to 30 dimmers EV 100 or EV 102,
• Up to 25 electronic ballasts at 20mA
• Possibility to memorize up to 3 different scene lighting levels.
In manual mode, the push-buttons situated on the product allow the
priority setting of the outputs when there is supply voltage on the
bus.
Dimming principles
Only one push-button is needed to order a dimming circuit according
to following principle :
• 1 brief press = start or stop
• 1 long press = increase or decrease
At each switching on, the dimmer restores the last stored level, except
when scenes are called.
The dimming control is also possible with 2 push-buttons :
• 1 push-button for start or increase by short or long press
• 1 push-button for stop or decrease by short or long press
ibemo Kazakhstan - 090301 Republic of Kazakhstan, West Kazakhstan Oblast, Aksai, Pramzone, BKKS office complex
Phone: +7 71133 93077 ; Fax: +7 71133 93074 ; E-Mail: info@ibemo-kz.com
5.33
Tebis TX