General Catalogue 2007 - Ibemo Kazakhstan Ltd

Instructions for use
Changing Pre-set parameters
1. Set dill switches to ON or OFF according to desired settings.
2. Hold the programmer vertically beneath the occupancy
sensor and press button A. The detector turns its load OFF
to indicate the beginning of a programming event and turns
back on almost immediately if the operation is a success. If
the detector output does not turn back on, repeat the
operation.
Parameter options for OS3/D, OS3/DS, OS4/D, OS4/DS, OS3/DSW and OS4/DSW
10.10
Options at end off delay
{
Fade to
off = Yes 5 min 10 min 20 min
Hager Catalogue 2007 • Technical
OSDP Digital Programmer
Setting the regulating light level
1. Point this unit at the occupancy sensor and adjust the light
output using the UP/DOWN buttons until the desired light
level is achieved locally.
Note: that it may not be possible to do this in the presence of
strong natural light.
2. Press STORE, two seconds later the load (regulating ballasts)
blinks to indicate a successful store operation. The occupancy
sensor will now regulate the light output in order to maintain the
level of illuminance at this new set point.
All of these parameters will be preserved in the event of power
loss and can be re-programmed any number of times.
1 2 3 4 5 6 7 8 9 10 11 12
Fade to
off = No
{
Off delay add together to
give required time
(All off = 10 sec walk test)
Off Off Off Lights turn off
On Off Off Lights stay at minimum output until next occupancy
Off On On Lights regulate below 25% for 3 hours then turn off
Off On Off Lights regulate below 25% until next occupancy
On Off On Lights stay at minimum output for 3 hours then turn off
Optimum settings to perform 10 second walk test
Switches Status
1-9 Off
10-12 On
Minimum
on-time
= 20 min
Minimum
on-time
= off delay
Bright-out
= Yes
Bright-out
= No
Occupancy
sensor
automatic
operation
Occupancy
sensor semi
-automatic
operation
Start
Full
Start
Low
Power Up
On
Power Up
Off
ibemo Kazakhstan - 090301 Republic of Kazakhstan, West Kazakhstan Oblast, Aksai, Pramzone, BKKS office complex
Phone: +7 71133 93077 ; Fax: +7 71133 93074 ; E-Mail: info@ibemo-kz.com
On
Off