Digilyzer DL1 User Manual
Digilyzer DL1 User Manual
Digilyzer DL1 User Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Connectors<br />
The <strong>Digilyzer</strong> includes the following connectors:<br />
AES3, 110 Ohm<br />
terminated<br />
Overview<br />
S/PDIF, 75 Ohm<br />
terminated<br />
Fig 2-09, Inputs and outputs of <strong>DL1</strong><br />
NOTES • For AES3, 75 Ohm, signals (BNC connector) use the<br />
attached Chinch-BNC adapter.<br />
• Insert a jack into the headphone output to switch<br />
of the analog monitoring with the internal speaker<br />
(e.g. during a live act).<br />
Rubber Cushions<br />
The original packaging of the <strong>Digilyzer</strong> includes a pair of rubber<br />
cushions. These may be adhered on the rear side of the device, so the<br />
output signal is made audible in good quality also whilst the <strong>Digilyzer</strong><br />
lays, e.g. on a table, with the speaker on the bottom side.<br />
Chinch-BNC Adapter<br />
The Chinch-BNC Adapter enables the measurement of the AES3id,<br />
75 Ohm standard with the <strong>Digilyzer</strong>. AES3id is especially required<br />
for the transmission of digital signals over longer cables with a cable<br />
length >100 m.<br />
13<br />
Headphone<br />
output<br />
TOS-Link /<br />
ADAT
Change language