Digilyzer DL1 User Manual

3. FIrsT sTeps
This chapter is a quick guide explaining how to make the first
measurements with the Digilyzer. The example assumes an S/PDIF
signal as input (e.g. a CD player with S/PDIF output playing a music
CD).
1. Insert batteries
2. Connect the S/PDIF signal to
the RCA input.
3. Reset the Digilyzer to default
state by holding down the
ESC key and simultaneously
pressing the ON button for
about two seconds.
4. Select S/PDIF as input
format
- Move the cursor (inverted box)
one step right to the format
menu by using the cursor
keys.
- Press the enter key to open
the format menu.
- Select S/PD and press the
enter key.
-> The channel status information
is displayed and music is
audible trough the built-in
speaker.
First Steps
15
3
2
Fig 3-01, Digilyzer
Fig 3-02, Format selection
4