Digilyzer DL1 User Manual

6. TrouBLesHooTING
In case the Digilyzer is malfunctioning the software may be reset to
factory set up as described below.
System Break Down
• Switch off the device.
• Reset the Digilyzer to the default status by pressing the ESC
button and switching on the Digilyzer simultaneously.
• Release the ESC button.
• The below screenshot will appear on the display stating on the
bottom line LOADING DEFAULT SETUP.
• Verify the correct operation.
Serial number
In case you find system breakdowns happening several times or your
device is malfunctioning, please note serial number and software
release number and contact the local NTi Audio representative in
your country.
For contact details see the NTi Audio web page: www.nti-audio.
com
Monitoring
Troubleshooting
Fig 6-01, Start up screen loading default setup
In two channel measurement functions (e.g. Level peak) the monitoring
signal of channel A and B are mixed together (stereo). In case one
of the channels is muted the stereo monitoring signal has a reduced
level.
50
Software
release
number